Tripp Lite MT-SE-37/02 owner manual Configuring the NMS, General Network Management Stations

Page 31

Tripp Lite

Configuring the NMS

To complete the SNMP Solo installation and configuration process, you must compile the necessary MIBs to configure the NMS.

Any NMS with a MIB compiler can manage the SNMP Solo adapter. For instructions on how to compile MIBs for the most popular NMSs—Novell’s NetWare Management Station, Hewlett-Packard’s OpenView Network Node Manager, and SunConnect’s SunNet Manager; see the corresponding heading below.

General Network Management Stations

Follow these general procedures to configure an NMS:

•Compile the device MIBs.

•Add SNMP Solo object to the Management Map.

•Ping the SNMP Solo.

HP OpenView Network Node Manager for HP-

UX

Compile the Device MIB

8.Copy the UPS MIB file from the TAR formatted diskette into the subdirectory /usr/OV/snmp_mibs.

9.From the main menu, select Options

10.Load/Unload MIBs: SNMP...

11.Select Load.

12.Select the MIB file copied earlier.

13.Select OK.

Add SNMP Solo Object to the Management Map

1.Select the submap then Edit: Add Object.

2.Select the group computer.

3.With the middle (or opposite) mouse button, drag the generic symbol subclass device to the submap.

Configuring the NMS

25

Image 31

Contents Snmp Solo Limited Warranty FCC Compliance Governing LawConventions Used In This Guide TrademarksTable of Contents Appendix Introduction Snmp Solo FeaturesExample Network With Snmp Solo Snmp Solo Package Snmp Solo Package ContentsStatus LEDs Power Supply Configuration CableTwo 3.5 Diskettes UPS Interface Cable System Requirements System Requirements Initial Installation Initial Installation Hardware adapter prior to configuring the device ConfigurationIP address Set IP And Gateway Addresses And MIB System GroupTripp Lite Configuration Access Controls Set Access ControlsSet Trap Receivers Trap Receivers Additional Setup Screen Additional Setup ScreenDisplay Settings To Save and Exit Reset Configuration to DefaultTelnet options TelNet OptionsExit Without Saving Upload FirmwareVerify the Snmp Solo Operation Final InstallationEstablish Network Communications General Network Management Stations Configuring the NMSPoll the Device OIDs From the Test Connectivity box Add Snmp Solo Object to the Management Map SunConnect SunNet ManagerPoll the Device OIDs IP Addresses AppendixReference CommunitiesClass Value of First Network ID Host ID Number Subnetting and Subnet MasksRouting and Filtering GatewaysAgent GlossaryOID Plugged into their respective ports TroubleshootingComputer System Placing a Technical Support Call773 Technical SupportReference Worksheet