Tripp Lite MT-SE-37/02 owner manual Set Trap Receivers

SNMP Solo

To set an access control, at the prompt type:

Set, <space>, enter the number of the column from 1 through 4, <space>, enter the IP address, <space>, name of the community string, <space>, and access code—rfor read only or w for read and write. Press <enter>. For example:

The new values display on the top of the screen:

To clear access controls of any manager IP address, type clear, <space>, and the desired list number at the prompt. Press <enter>.

The top of the screen reflects your changes:

To return to the Main Menu, type 0 and press <enter>.

Set Trap Receivers

Use this screen to determine which IP managers receive traps (messages) from your SNMP Solo. This screen permits you to send traps about your UPS to four IP addresses (managers). Also, you may determine the severity levels to assign to a particular manager. To access the trap setting screen, type 3 from the Main Menu. The following screen displays:

16Configuration