Tripp Lite MT-SE-37/02 owner manual TelNet Options, Telnet options

Page 27

Tripp Lite

This messages informs or directs you:

1.The Setup program has ended.

2.Turn off the DIP switch (switch 1 UP).

3.Disconnect the power supply from the SNMP Solo.

4.Re-connect the power supply to the SNMP Solo.

TelNet Options

You can also TelNet to the IP address of the SNMP Solo after it has been installed on your network. Once you have successfully established a TelNet connection with the adapter you may access the configuration menu as if you were directly attached to it via the configuration port.

Figure 13 Telnet options

The TelNet options menu gives some additional features that you can use after you have established a TelNet connection.

Configuration21

Image 27

Contents Snmp Solo Limited Warranty FCC Compliance Governing LawConventions Used In This Guide TrademarksTable of Contents Appendix Introduction Snmp Solo FeaturesExample Network With Snmp Solo Snmp Solo Package Snmp Solo Package ContentsStatus LEDs Configuration Cable Power SupplyTwo 3.5 Diskettes UPS Interface Cable System Requirements System Requirements Initial Installation Initial Installation Hardware adapter prior to configuring the device ConfigurationIP address Set IP And Gateway Addresses And MIB System GroupTripp Lite Configuration Access Controls Set Access ControlsSet Trap Receivers Trap Receivers Additional Setup Screen Additional Setup ScreenDisplay Settings To Save and Exit Reset Configuration to DefaultTelnet options TelNet OptionsExit Without Saving Upload FirmwareVerify the Snmp Solo Operation Final InstallationEstablish Network Communications General Network Management Stations Configuring the NMSPoll the Device OIDs From the Test Connectivity box Add Snmp Solo Object to the Management Map SunConnect SunNet ManagerPoll the Device OIDs IP Addresses AppendixReference CommunitiesClass Value of First Network ID Host ID Number Subnetting and Subnet MasksRouting and Filtering GatewaysAgent GlossaryOID Plugged into their respective ports TroubleshootingComputer System Placing a Technical Support Call773 Technical SupportReference Worksheet