Tripp Lite MT-SE-37/02 owner manual System Requirements

Page 13

Tripp Lite

System Requirements

SNMP Solo requires a terminal for configuration and a network connection with an NMS for operation. The following is a description of all required components and a list of the most widely used NMSs.

The components of your standard SNMP Solo package

Connection to an EtherNet network

An SNMP-based management station

Some NMSs that support the SNMP Solo are:

HP OpenView for UNIX

HP OpenView for Microsoft Windows

Novell NMS

SunConnect SunNet Manager

IBM NetView/6000

A dumb terminal or a PC with an emulation package to configure the SNMP Solo SNMP Agent

An RS232 communication port on your PC or terminal

A UPS—any UPS type

You can interface any contact closure UPS with SNMP Solo if you have the manufacture’s specific cable supplied with your kit.

Network identification values for the SNMP Solo:

IP Address

Net Mask

IP Addresses for the NMS

Definitions of Communities

IP Address of the Gateway/Router

System Requirements

7

Image 13
Contents Snmp Solo Limited Warranty FCC Compliance Governing LawConventions Used In This Guide TrademarksTable of Contents Appendix Introduction Snmp Solo FeaturesExample Network With Snmp Solo Snmp Solo Package Snmp Solo Package ContentsStatus LEDs Power Supply Configuration CableTwo 3.5 Diskettes UPS Interface Cable System Requirements System Requirements Initial Installation Initial Installation Hardware adapter prior to configuring the device ConfigurationIP address Set IP And Gateway Addresses And MIB System GroupTripp Lite Configuration Access Controls Set Access ControlsSet Trap Receivers Trap Receivers Additional Setup Screen Additional Setup ScreenDisplay Settings To Save and Exit Reset Configuration to DefaultTelnet options TelNet OptionsExit Without Saving Upload FirmwareVerify the Snmp Solo Operation Final InstallationEstablish Network Communications General Network Management Stations Configuring the NMSPoll the Device OIDs From the Test Connectivity box Add Snmp Solo Object to the Management Map SunConnect SunNet ManagerPoll the Device OIDs Reference AppendixCommunities IP AddressesClass Value of First Network ID Host ID Number Subnetting and Subnet MasksRouting and Filtering GatewaysAgent GlossaryOID Plugged into their respective ports TroubleshootingComputer System Placing a Technical Support Call773 Technical SupportReference Worksheet