Paradyne 8546, 8540 manual Configuring MCC Cards, DSL Cards, and RTUs

Configuring the HotWire DSLAM

Configuring MCC Cards, DSL Cards, and RTUs

Use the procedures in the following order to configure the MCC and DSL cards for the basic setup for terminal management and user data connectivity.

NOTE:

It is assumed that you have read the HotWire DSLAM for 8540 and 8546 DSL Cards Network Configuration Guide and have assigned service and management domain IP addresses for all devices (MCC, DSL, and RTUs). For your convenience, Appendix A of the Network Configuration Guide contains worksheets to record your configuration settings.

The following tables list the basic steps you need to configure the MCC cards,

DSL cards, and RTUs.

For the Management Domain,		On the . . .	See . . .
perform task . . .
1.	Configure time and date.	MCC	Setting Time and Date Screen,
			page 4-6.
2.	Assign the IP address to the	MCC	Assigning IP Addresses to the
	backplane on the MCC card.		Backplane on the MCC Card,
			page 4-7.
3.	Assign the IP addresses to the	MCC	Assigning IP Addresses to the DSL
	DSL cards.		Cards on the MCC Card,
			page 4-8.
4.	Create SNMP Community	MCC	Creating SNMP Community
	Strings and Authentication		Strings and Authentication Failure
	Failure Trap.		Trap, page 4-9.
5.	Create default route.	MCC	Creating the Default Route,
			page 4-10.
6.	Reset the MCC card.	MCC	Resetting the MCC Card,
			page 4-11.
7.	Select a DSL card to configure.	DSL	Selecting a DSL Card to
			Configure, page 4-11.
8.	Configure 5446 RTU IP host	DSL	Configuring 5446 RTU IP Host
	address for the 8546 DSL card.		Addresses on the 8546 DSL Card,
	(Not applicable to 8540 DSL		page 4-12.
	card.)

4-2 November 1997 8000-A2-GB20-20