Paradyne 8540, 8546 manual Physical Layer Options 2

Page 105

Monitoring the HotWire DSLAM

Table 7-7. Physical Layer Options (2 of 5)

Ether Statistics (Ethernet Statistics)

B-B-B

 

 

Displays a list of the Ethernet statistics of the LAN port (e1a) such as port name, LAN address, bytes (running account of how many bytes have been received since last reset), packets (running account of how many packets have been received since last reset) and errors received and transmitted, number of disconnects, number of fast restarts, number of endless and startless packets, and amount of babble.

You may enter Ctrl-r at any time to reset counters.

Port ± Type of port (e1a).

Initialized Ethernet Ports ± e1a (There is only one other net port on the card).

LAN Address ± LAN (or MAC) address of the Ethernet port.

Bytes received ± Number of bytes received by the Ethernet port.

Bytes transmitted ± Number of bytes transmitted by the Ethernet port.

Packets received ± Number of packets transmitted by the Ethernet port and what type (multicasts, broadcasts, flooded, local origin, queued).

±Multicast ± Single packets copied to a specific subset of network addresses.

±Broadcasts ± Messages sent to all network destinations.

±Flooded ± Information received, then sent out to each of the interfaces.

±Filtered ± Processes or devices that screen incoming information.

±Discarded ± Packets discarded.

Errors ± Number of errors transmitted by the Ethernet port and what type (collisions, M/L/E, deferrals, carrier loss, underflow, buffer). M = multi-collision frames ± not counted this release and always set to 0. L = late collisions ± collision detected often; at least

64 bytes have been transmitted. E = excessive collisions ± port tried to send a packet 15 times without success.

±Overruns ± No buffer space.

±Bad CRC ± Cyclic Redundancy Check.

±Framing ± Receiver improperly interprets set of bits within frame.

±Jumbo gram ± Ethernet packet too long.

±Overflow ± Part of traffic that is not carried.

±Buffer ± No buffer space.

Bytes transmitted ± Number of bytes transmitted on the Ethernet port.

Fast restarts ± Number of fast restarts and what type (RX off, TX off, Mem err).

Endless Pkt ± Number of endless packets received on the Ethernet port.

Startless Pkt ± Number of startless packets received on the Ethernet port.

Babble ± Number of garbled packets received due to crosstalk.

8000-A2-GB20-20

November 1997

7-17

Page 104 Page 106
Image 105
Page 104 Page 106
Contents Hotwire Dslam for 8540 and 8546 DSL Cards Copyright  1997 Paradyne Corporation All rights reserved Contents Initial Setup Instructions DSL Card Configuration Diagnostics and Troubleshooting Static Route Warning Messages Glossary Index Document Purpose and Intended Audience About This GuideSection Description Document SummarySection Description Product-Related DocumentsWhat is the HotWire DSLAM? HotWire Dslam System DescriptionHotWire Dslam Components Network Service Provider Central Office COCustomer Premises CP One Management Communications Controller MCC card Features Levels of AccessHotWire Dslam Software Functionality Monitoring the System Configuring the SystemTroubleshooting and Diagnostics Overview HotWire Menus and ScreensMenu and Screen Formats Components of a HotWire MenuComponents of a HotWire Screen HotWire 8800 MCC 8000 Keys Definition Commonly Used Navigation KeysHotWire Chassis Main Menu HotWire Menus a Hierarchical ViewHotWire-MCC HotWire ± MCC MenuDiagnostics ApplicationsPorts Users ConfigurationCard Status InterfacesMonitoring Physical LayerNetwork Protocol HotWire ± DSL Menu IP Router Dhcp Relay PortsPPP Stats Card/CPE StatusOperator Login Screen Reviewing the Levels of AccessPosition Display Description Card Selection ScreenProcedure Accessing the HotWire ± MCC MenuExiting From the System Manually Logging OffAutomatically Logging Off Accessing the System for the First Time Initial Setup InstructionsInitial Setup Instructions Additional Setup Instructions Whats Next? Chassis Information ScreenField Input Description Port Naming Convention Configuring the HotWire DslamFor the Management Domain See Perform task Configuring MCC Cards, DSL Cards, and RTUsFor each Service Domain See Perform task Server 10BT DCE Manager Router DCE ManagerMCC Card DSL CardISP Router Service DomainField Description Input Setting Time and Date ScreenNet Assigning IP Addresses to the Backplane on the MCC CardAssigning IP Addresses to the DSL Cards on the MCC Card Select Configuration → Snmp → Communities/Traps A-F-D Select Configuration → IP Router→ StaticRoutes A-E-A Creating the Default RouteSelecting a DSL Card to Configure Resetting the MCC CardHost Configuring 5446 RTU IP Host Addresses on the 8546 DSL CardSelect Configuration → IP Router → StaticRoutes A-E-A Configuring a Static Route to an NMS on each DSL CardAssigning IP Addresses to the DSL Card LAN Resetting the DSL Card Configuring Static Routes to End Users on each DSL Card Configuring Dhcp Relay Agent dynamic addressing Creating Default Route or Source Route on the DSL MCC Configuration Card Status Screens MCC Card ConfigurationDNS Setup Configure DNS Card Status Menu Options 1Card Info System Information Card Status Menu Options 2 Card Status Menu Options 3 Card Reset Reset SystemDownload Code Download Code and Apply Download Apply DownloadMCC Configuration Interfaces Screens MCC Configuration Ports Screens Reserved for Future UseInterfaces Menu Options 1 General InterfacesIP Network Interfaces Menu Options 2Base Subnet Mask ± nnn.nnn.nnn.nnn format Input Filter ± Optional Output Filter ± OptionalMCC Configuration Users Screens Users Configure AccountUsers Menu Options IP Router Menu Options 1 MCC Configuration IP Router ScreensStatic Routes Martian NetworksFilter Table IP Router Menu Options 2Delete Rule ± Yes/No Go to Rule Number ± Default = IP Router Filters IP Filter ConfigurationIP Router Menu Options 3 Destination Address ± nnn.nnn.nnn.nnn formatParameters a IP Router Menu Options 4IP Address/Host Name ± nnn.nnn.nnn.nnn format Delete Entry Delete ARP Entry CSnmp Menu Options 1 MCC Configuration Snmp ScreensSecurity Snmp Security Logical Entities Snmp Logical EntitiesCommunities/Traps Snmp Communities/Traps Snmp Menu Options 2DSL Options MCC DSL Cards ScreenDSL Configuration Card Status Screens DSL Card ConfigurationCard Status Options 1 Card Status Options 2 Card Status Options 3 Card Status Menu Options 4 Ports Options 1 DSL Configuration Ports ScreensEthernet Port DSL Ports DSL ParametersPorts Options 2 Interfaces Options 1 DSL Configuration Interfaces ScreensInterfaces Options 2 Interfaces Options 3 Echo Policy Default =Negotiate Options Link OptionsUsers Options DSL Configuration Users ScreensIP Router Options 1 DSL Configuration IP Router ScreensIP Router Options 2 Delete Rule ± Yes/No Go to Next Rule ± Yes/No IP Router Options 3Delete ARP Entry Delete ARP EntryC IP Router Options 4Snmp Options 1 DSL Configuration Snmp ScreensSnmp Options 2 DSL Configuration Dhcp Relay Screens Domain Names Dhcp Relay OptionsServers 1±8 and Servers 9±16 B or C Servers 1±8 BDSL Configuration RTU Screens RTU InformationRTU Information MCC Monitoring Menu Tree Monitoring the HotWire DslamLogin History MCC Monitoring Card Status ScreensCard Info General Card Information Physical Layer Options 1 MCC Monitoring Physical Layer ScreensSyslog Active List Active Ports ListPhysical Layer Options 2 Ether Statistics Ethernet StatisticsHdlc Bus Stats Hdlc Bus Statistics Interfaces Options MCC Monitoring Interfaces ScreensActive List Active Interfaces List Status Interface StatusMCC Network Protocol Screens Network Protocol Options 1Socket Statistics UDP Statistics Network Protocol Options 2TCP Data Stats TCP Statistics Network Protocol Options 3Network Protocol Options 4 TCP Connection StatisticsIP Statistics Network Protocol Options 5 Icmp Statistics Icmp Packet StatisticsSnmp Statistics Snmp Authentication Statistics Network Protocol Options 6Hdlc Stats Hdlc Statistics MCC IP Router Screens Routing TableRouting Table Screen ARP Table Routing Information WindowDSL Monitoring Card Status Screens DSL Monitoring Menu TreeCard Status Options DSL Monitoring Physical Layer Screens Physical Layer Options 2 Physical Layer Options 3 Physical Layer Options 4 DSL Link Perf DSL Link Performance SummaryDSL Perf Stats DSL Performance Stats DSL Error Stats Physical Layer Options 5DSL Xmit Status DSL Transmit Stats DSL Monitoring Interfaces Screens DSL Network Protocol Screens Network Protocol Options 2 TCP Data Stats TCP Data Statistics Network Protocol Options 4 Network Protocol Options 5 Hdlc Statistics Hdlc Statistics PPP Stats General H a Network Protocol Options 7LCP Stats PPP H B Ipcp General Stats PPP H C10. IP Router Options 1 DSL IP Router ScreensRouting Table Routing Information Window 10. IP Router Options 210. IP Router Options 3 11. RTU Information Applications Screens Diagnostics and TroubleshootingPing MCC and DSL Applications OptionsTraceRoute Telnet MCC Card onlyDiagnostic Screens Alarms Card Alarms Diagnostics OptionsSelftest Packet Echo TestModel # M R D U X X TroubleshootingMajor Alarms 1 Failure Type Action Checking AlarmsEthernet port 1. Check cable connections to the Dslam Major Alarms 2 Failure Type ActionMinor Alarms 1 Failure Type Action MarginThreshold Error Rate Failure Type ActionLink Down Network Problems Excessive Collisions Slow PerformanceFilters Not Working No Snmp Connection EstablishedIP Routing Problems No PPP TrafficNo Response at Start Up System Does Not Recognize New DSL Cards Large Number of TrapsCannot Communicate with Interface Cannot Upload Configurations to a Unix Server Unexpected Subnet DataCannot Communicate with 5446 RTU from MCC Card MCC User Accounts For Telnet Terminal Access to MCC Card DSL User Accounts Reboot Card MCCReboot Card DSL Setting Up Snmp Features Checklist for Setting Up Snmp FeaturesMCC Snmp Community Strings and Authentication Failure Trap Management System Source Validation for MCCEnable DSL Port Traps DSL Snmp Community Strings and Authentication Failure TrapEnable/Disable Endpoint Security to 5446 RTU Management System Source Validation for DSL cardsDownload Code and Apply Download CodeScenario One Fully Operational System Scenario Two Download Only System Apply DownloadNavigation Keys Event Trap Class Comment TrapsTraps Traps MCC card sends the following traps RTU Related Traps Standard TrapsEnterprise-Specific Traps RTU Setup Accessing 5446 RTU MIBsRTU Overview Network Management Systems IP Injection ToolIP Injection MIB OID MIB Browser TechniquesUsing the null entry IP and Device MIBs Supported RTU IP Configuration Table± Mask Additional pdn-common MIBs SupportedMessage Meaning Static Route Warning MessagesGlossary Ethernet Address EthernetFilter Gateway addressMCC Card MarginMultiplex PacketRouting Table RouterS1b S1cNumbers IndexIN-2 IN-3
Related manuals
Manual 132 pages 42.56 Kb Manual 12 pages 4.86 Kb
Top Page Image Contents