Polycom 6.1 user manual 107 RN

These fields should be completed as follows:

Address Field: Enter the address of the encoder. The default “loop back” address is typically “127.0.0.1”.

Port Field: Enter the Port that the encoder is using. The port number can be found in the PE Controller Configuration window (See Figure 4-105).

Fig. 4-105

Password Field: Enter the password that was entered in the PE-Controller to access the encoder.

Admin Password Field: Enter the admin password that was entered in the PE- Controller to provide administration rights (See Figure 4-106).

Fig. 4-106

Note: Unless encoder profiles are going to be changed, it is often not necessary to enter an administration password.

Clicking the Configure button will launch the Encoder Settings window for the encoder, either Real or Microsoft, that is being configured (See Figures 4-107 through 4-109 and 4-110 though 4-112, respectively).

Fig. 4-107 (RN) Fig. 4-108 (RN)

49