Delta Electronics VFD-XXXE quick start Group 7 Motor Parameters, Fla

Pr.

Explanation

Settings

Factory Setting

NOTE

		27: DCBUS error (cF3.3)
		28: IGBT Overheat (cF3.4)
		29: Power Board Overheat (cF3.5)
		30: Control Board CPU WRITE failure
06.11	Fourth Most Recent	(cF1.1)
	Fault Record	31: Control Board CPU WRITE failure
		(cF2.1)
		32: ACI signal error (AErr)
		33: Reserved
06.12	Fifth Most Recent	34: Motor PTC overheat protection (PtC1)
	Fault Record	35-39: Reserved
		40: Communication time-out error of control
		board and power board (CP10)
		Group 7 Motor Parameters
07.00	Motor Rated Current	30 %FLA to 120% FLA	FLA
	(Motor 0)
07.01	Motor No-Load	0%FLA to 99% FLA	0.4*FLA
	Current (Motor 0)
	Torque
07.02	Compensation	0.0 to 10.0	0.0
	(Motor 0)
	Slip Compensation	0.00 to 10.00	0.00
07.03	(Used without PG)
	(Motor 0)
	Motor Parameters	0: Disable
07.04		1: Auto tuning R1	0
	Auto Tuning
		2: Auto tuning R1 + no-load test
	Motor Line-to-line	0~65535 mΩ
07.05	Resistance R1		0
	(Motor 0)
07.06	Motor Rated Slip	0.00 to 20.00 Hz	3.00
	(Motor 0)
07.07	Slip Compensation	0 to 250%	200
	Limit
	Torque
07.08	Compensation Time	0.01 ~10.00 Sec	0.30
	Constant
07.09	Slip Compensation	0.05 ~10.00 sec	0.20
	Time Constant
	Accumulative Motor
07.10	Operation Time	0 to 1439 Min.	0
	(Min.)
	Accumulative Motor
07.11	Operation Time	0 to 65535 Day	0
	(Day)
07.12	Motor PTC	0: Disable	0
	Overheat Protection	1: Enable
	Input Debouncing
07.13	Time of the PTC	0~9999(*2ms)	100
	Protection
	Motor PTC
07.14	Overheat Protection	0.1~10.0V	2.4
	Level

English- 22