Controlling
Analog Picture Controls
The analog picture controls can be adjusted with the RCU. The control keys are located on the lower right side of the key panel of the RCU and indicated with the name of the control and an icon.
When an analog picture control is pressed, a text box with bar scale and the function name of the control, e.g. 'brightness...' appears on the screen (only if 'TEXT' is ON). The length of the bar scale indicates the current memorized setting for this source. The bar scale changes as the + or - buttons of the control are pressed.
Brightness Control
A correct 'brightness' setting is important for good image reproduction. Adjust the brightness with the + button and - button (RCU) until the darkest parts of the picture appear black.
A bar scale gives a visual indication on the screen of the current brightness setting
BRIGHTNESS |
36 |
while pressing on the above indicated keys. If the bar scale is not visible on the screen, press 'TEXT' key once and retry the above indicated keys.
The bar scale increases when pressing on the + button (higher brightness) and decreases when pressing on the - button (lower brightness).
Contrast Control
A correct 'contrast' setting is important for good image reproduction.
Adjust the contrast to the level you prefer, according to room lighting conditions. If the Contrast Control is too low, the picture will be too dim. If it is set too high, the picture may be too bright and not sharp.
A bar scale gives a visual indication on the screen of the current contrast setting while pressing the + or - buttons (RCU). If the bar scale is not visible on the screen, press 'TEXT' key once and retry the above indicated keys.
The bar scale increases when pressing on the + button (higher contrast) and decreases when pressing on the - button (lower contrast).
Color Saturation Control
Color saturation is only active for Video and
Tint Control
Tint is only active for Video and
The bar scale increases when pressing on the + button (greener flesh tones) and decreases when pressing the - button (redder flesh tones).
Sharpness Control.
Sharpness control only active for Video and
Controlling chained projectors.
Projectors can be controlled individually as well as in a group.
For individual control see previous pages.
For group control of the projectors.
(input selection and analog picture control)
Program the 'zero address' into any RCU. Therefore, press on the address key and key in the address ("0") with the numeric keys on the RCU itself.
Once address '0' is pressed, all projectors will be controlled together until a new address is entered on the RCU. It is possible to have a common input selection and a common analog picture control.
Once a new address is entered, only the projector with that specific address will follow the new instructions.
Note : For group control, all projectors in a control group must be capable of receiving the IR signal from the controlling RCU at the same time.
| 5975688 BARCOVISION 1609S 131097 | |
|