E
Using the Utility Program
In order to use the floppy disk adaptor, you first have to run the ReadFlashPath data read utility.
1Quit all programs and ensure that only the Finder is running.
The ReadFlashPath utility operates under the assumption that is running alone.
2Start up the ReadFlashPath utility only from your hard drive or from a hard drive directly connected to your computer.
This utility software is valid only when it has been installed in the hard drive which is connected directly to the Macintosh in use. Do not attempt to run this utility from a remote hard drive located on a network.
Avoid installing the same data read utility program more than once. Do not run two versions of this program
concurrently. Always open the utility by
3Once the program has finished loading, the Finder menu bar will be replaced by the ReadFlashPath utility menu.
Do not try to perform any operation until the program has finished loading (the ReadFlashPath menu bar appears).
42