Planar Dome EX manual Connect the Video and Power Cables, To connect the cables

Page 19

Connect the Video and Power Cables

Turn your computer off. Leave the power cord plugged into the grounded outlet. Use the Dome EX display with the power adapter and video cable shipped.

For the Dome E2 display, the power adapter is the Ault MW116KA1249F53.

For the Dome E3, Dome E3c, and Dome E5 displays, the power adapter is the Ault MW122RA1223F52.

To connect the cables

1Plug one end of the DVI cable into the DVI port on the interface plate. Secure the connection.

2Plug the power cord into the power input port on the interface plate.

3Plug the other end of the DVI cable into the Video 1 port on the installed display controller. Secure the connection.

4Plug the other end of the power cord into the power supply.

5 Plug the power supply cord into a grounded AC outlet.

Connect the power cord and DVI cable to the interface plate on the back on the display.

Connect one or two displays to the controller board installed in your computer.

Installing the Display 9

Image 19

Contents User’s Guide Dome EX DisplayPlanar Systems, Inc. All rights reserved Contents Product Information Intended use Symbol explanationsSafety tips Safety precautionsPreventing fire and injury Unpacking and handling tipsCleaning the display Disposal information Shipping/storing the displayDVI cable About the Display System Requirements Display Components Viewing angle Orientation modeDisplay Positions Tilt range Height rangeUSB hub Desk Stand FeaturesStand height lock Stand cable coverInstalling the Display Tips Set the DIP Switch on the Dome DX2 BoardTo install the display controller Install the Display ControllerTo connect the cables Connect the Video and Power CablesTo change the display properties Install the Dome DX Display DriverTo install the driver To enable the displayTo set driver options To set the resolution and paletteAuto-orientation To set brightnessTo configure the display Install the AX3 Display DriverTo set the display mode manually To adjust the display propertiesTo use a dual-display configuration Appendix Problem Possible Cause Solution TroubleshootingCategory Characteristic Item Specification Dome E2 SpecificationReliability Power SupplyEnvironment Model Dome E3 SpecificationDome E3 Specification Dome E3 Specification EMI shielding No emission of low-level radiation Temperature Dome E3c Specification Display Mtbf 30,000 hours Backlight Dome E5 Specification Dome E5 Specification Video Modes Details of DIN connectors Connector PortsLED Status Lights LED a status information after initial power-on Power-up sequence information from LEDLED B status information after initial power-on Single Desktop To set the display resolutionRestoring dual heads To change the configuration to single desktopSystem configuration requirement Auto-InstallationInstallation options Prompting user response during Fastinst.bat To remove the Dome DX driver Display Driver RemovalTo remove the AX3 driver Power Management Grayscale Palette Options Nonlinear static gray palette Palette options with multiple displaysDesktop icons Dynamic gray paletteStatic gray palette Index Using single desktop Canada, European Union, United States Regulatory CompliancePage Fax + 358 9 420 EU Declaration of Conformity for Medical Application FCC Compliance Statement Korea AustralianChina JapanStandard Warranty Return Procedure Standard WarrantySummary Limitation of Implied Warranties Summary Limitations and Exclusions of Dome DisplaysEffect of Local Law Exclusion of DamagesMedicalsales@planar.com Medicalsupport@planar.com