Planar Dome EX manual FCC Compliance Statement

Page 57

U.S. FCC Compliance Statement

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technical for help. CAUTION: Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Image 57

Contents User’s Guide Dome EX DisplayPlanar Systems, Inc. All rights reserved Contents Product Information Intended use Symbol explanationsSafety tips Safety precautionsPreventing fire and injury Unpacking and handling tipsCleaning the display Disposal information Shipping/storing the displayDVI cable About the Display System Requirements Display Components Display Positions Orientation modeTilt range Height range Viewing angleStand height lock Desk Stand FeaturesStand cable cover USB hubInstalling the Display Tips Set the DIP Switch on the Dome DX2 BoardTo install the display controller Install the Display ControllerTo connect the cables Connect the Video and Power CablesTo install the driver Install the Dome DX Display DriverTo enable the display To change the display propertiesAuto-orientation To set the resolution and paletteTo set brightness To set driver optionsTo configure the display Install the AX3 Display DriverTo adjust the display properties To set the display mode manuallyTo use a dual-display configuration Appendix Problem Possible Cause Solution TroubleshootingCategory Characteristic Item Specification Dome E2 SpecificationPower Supply ReliabilityEnvironment Model Dome E3 SpecificationDome E3 Specification Dome E3 Specification EMI shielding No emission of low-level radiation Temperature Dome E3c Specification Display Mtbf 30,000 hours Backlight Dome E5 Specification Dome E5 Specification Video Modes Details of DIN connectors Connector PortsLED Status Lights Power-up sequence information from LED LED a status information after initial power-onLED B status information after initial power-on Single Desktop To set the display resolutionRestoring dual heads To change the configuration to single desktopSystem configuration requirement Auto-InstallationInstallation options Prompting user response during Fastinst.bat Display Driver Removal To remove the Dome DX driverTo remove the AX3 driver Power Management Grayscale Palette Options Desktop icons Palette options with multiple displaysDynamic gray palette Nonlinear static gray paletteStatic gray palette Index Using single desktop Canada, European Union, United States Regulatory CompliancePage Fax + 358 9 420 EU Declaration of Conformity for Medical Application FCC Compliance Statement China AustralianJapan KoreaStandard Warranty Standard Warranty Return ProcedureSummary Limitation of Implied Warranties Summary Limitations and Exclusions of Dome DisplaysEffect of Local Law Exclusion of DamagesMedicalsales@planar.com Medicalsupport@planar.com