Planar Dome EX manual Prompting user response during

Page 44

-s	Silent mode. Use a response file instead
	of prompting user response during
	installation.
-f1<path\response file>	Use the response file specified during
	installation. If no -f1 switch is given, the
	installation uses the response file in the
	same directory in which setup.exe
	resides.
-f2<path\log file>	Save any output to the log file specified
	during installation. If no -f2 switch is
	given, the installation saves to the log
	file in the same directory in which the
	response file resides. This may cause
	a problem if setup is run from the CD-
	ROM drive.
-remove	Run uninstallation.
-bit8	Set all Dome CX or Dome EX displays to
	8-bit mode (default).
-bit32	Set all Dome CX or Dome EX displays to
	32-bit mode. Grayscale switches are
	ignored when this switch is specified.
-static	Set 8-bit mode to static gray palette
	(default).
-notstatic	Set 8-bit mode to dynamic gray palette.
-yesddraw	Enable DirectDraw (default).
-noddraw	Disable DirectDraw.
-autodetect	Enable AutoOrientation for Dome EX
	displays (default).
-noautodetect	Set all displays to portrait orientation.

34 Dome EX Display

Image 44

Contents Dome EX Display User’s GuidePlanar Systems, Inc. All rights reserved Contents Product Information Symbol explanations Intended useSafety precautions Safety tipsUnpacking and handling tips Preventing fire and injuryCleaning the display Shipping/storing the display Disposal informationDVI cable About the Display System Requirements Display Components Orientation mode Display PositionsTilt range Height range Viewing angleDesk Stand Features Stand height lockStand cable cover USB hubInstalling the Display Set the DIP Switch on the Dome DX2 Board TipsInstall the Display Controller To install the display controllerConnect the Video and Power Cables To connect the cablesInstall the Dome DX Display Driver To install the driverTo enable the display To change the display propertiesTo set the resolution and palette Auto-orientationTo set brightness To set driver optionsInstall the AX3 Display Driver To configure the displayTo use a dual-display configuration To adjust the display propertiesTo set the display mode manually Appendix Troubleshooting Problem Possible Cause SolutionDome E2 Specification Category Characteristic Item SpecificationEnvironment Power SupplyReliability Dome E3 Specification ModelDome E3 Specification Dome E3 Specification EMI shielding No emission of low-level radiation Temperature Dome E3c Specification Display Mtbf 30,000 hours Backlight Dome E5 Specification Dome E5 Specification Video Modes Connector Ports Details of DIN connectorsLED Status Lights LED B status information after initial power-on Power-up sequence information from LEDLED a status information after initial power-on To set the display resolution Single DesktopTo change the configuration to single desktop Restoring dual headsAuto-Installation System configuration requirementInstallation options Prompting user response during Fastinst.bat To remove the AX3 driver Display Driver RemovalTo remove the Dome DX driver Power Management Grayscale Palette Options Palette options with multiple displays Desktop iconsDynamic gray palette Nonlinear static gray paletteStatic gray palette Index Using single desktop Regulatory Compliance Canada, European Union, United StatesPage Fax + 358 9 420 EU Declaration of Conformity for Medical Application FCC Compliance Statement Australian ChinaJapan KoreaSummary Standard WarrantyStandard Warranty Return Procedure Summary Limitations and Exclusions of Dome Displays Limitation of Implied WarrantiesExclusion of Damages Effect of Local LawMedicalsales@planar.com Medicalsupport@planar.com