Planar Dome EX Install the Dome DX Display Driver, To install the driver, To enable the display

Page 20

Install the Dome DX Display Driver

Before you install the driver, remove any previously installed display driver for the display controller from your system.

To install the driver

1Log on with administrator privileges. The InstallShield Wizard reports new hardware.

2Click Cancel. You must run Setup.exe to install the driver.

3 Insert the W2KDXPCI CD and open the CD folder. 4 Double-click Setup.exe.

5 Click Next to proceed and start copying files.

6If the Digital Signature Not Found message appears, click Yes or Continue to complete the driver installation.

7 Select Yes, I want to restart my computer now, and click Finish.

To enable the display

1 Log on with administrator privileges.

2Right-click the desktop. Select Properties > Settings.

3 Select the display icon.

4 Select Extend my Windows desktop onto this monitor. Click Apply. 5 Click OK.

To change the display properties

Use the Dome tab to change display properties after the Dome EX display is attached to the Windows desktop. Otherwise, use Properties > Settings tab.

To determine screen assignments

Click Identify in the Settings tab to match screens to display controllers. (Windows 2000 renumbers and reassigns screens as you add them to the configuration. Set resolutions or preferences only after all display controller and screens are installed. Restart your system to make sure the screen assignments are retained.)

10 Dome EX Display

Image 20

Contents Dome EX Display User’s GuidePlanar Systems, Inc. All rights reserved Contents Product Information Symbol explanations Intended useSafety precautions Safety tipsUnpacking and handling tips Preventing fire and injuryCleaning the display Shipping/storing the display Disposal informationDVI cable About the Display System Requirements Display Components Orientation mode Display PositionsTilt range Height range Viewing angleDesk Stand Features Stand height lockStand cable cover USB hubInstalling the Display Set the DIP Switch on the Dome DX2 Board TipsInstall the Display Controller To install the display controllerConnect the Video and Power Cables To connect the cablesInstall the Dome DX Display Driver To install the driverTo enable the display To change the display propertiesTo set the resolution and palette Auto-orientationTo set brightness To set driver optionsInstall the AX3 Display Driver To configure the displayTo use a dual-display configuration To adjust the display propertiesTo set the display mode manually Appendix Troubleshooting Problem Possible Cause SolutionDome E2 Specification Category Characteristic Item SpecificationEnvironment Power SupplyReliability Dome E3 Specification ModelDome E3 Specification Dome E3 Specification EMI shielding No emission of low-level radiation Temperature Dome E3c Specification Display Mtbf 30,000 hours Backlight Dome E5 Specification Dome E5 Specification Video Modes Connector Ports Details of DIN connectorsLED Status Lights LED B status information after initial power-on Power-up sequence information from LEDLED a status information after initial power-on To set the display resolution Single DesktopTo change the configuration to single desktop Restoring dual headsAuto-Installation System configuration requirementInstallation options Prompting user response during Fastinst.bat To remove the AX3 driver Display Driver RemovalTo remove the Dome DX driver Power Management Grayscale Palette Options Palette options with multiple displays Desktop iconsDynamic gray palette Nonlinear static gray paletteStatic gray palette Index Using single desktop Regulatory Compliance Canada, European Union, United StatesPage Fax + 358 9 420 EU Declaration of Conformity for Medical Application FCC Compliance Statement Australian ChinaJapan KoreaSummary Standard WarrantyStandard Warranty Return Procedure Summary Limitations and Exclusions of Dome Displays Limitation of Implied WarrantiesExclusion of Damages Effect of Local LawMedicalsales@planar.com Medicalsupport@planar.com