Planar Dome EX manual Dome E5 Specification

Page 34

Dome E5 Specification

Model 933-0544-00

In locations where 240V outlets are used, connect the Dome E5 display to only a center- tapped, 240V, single-phase supply (only for Canada and the United States).

Category

Characteristic Item

Specification

 

 

 

Screen

Screen size diagonal

510 mm (20.1 in.)

 

Resolution

2048 x 2560 pixels (portrait)

 

 

2560 x 2048 pixels (landscape)

 

Pixel pitch

0.156 mm, 163 ppi

 

Pixel arrangement

Subpixel vertical stripe

 

Active area (mm)

399.4 (H) x 319.58 (V)

 

Grayscale supported

3061 shades of gray

 

Refresh rate

60 Hz

 

Contrast ratio

600:1 (typical)

 

Brightness

850 cd/m2 (typical)

 

Pixel rise/fall time

30 ms (typical)

 

Viewing angle

170° (± 85°) horizontal/vertical

 

 

 

Interface

Digital Video In

DVI Rev. 1.0 single digital channel connector

 

 

 

 

Display control - brightness/

DDC2B+

 

contrast

 

 

Display identification

EDID read using DDC2B+

 

USB hub

Universal Serial Bus (USB) Rev. 1.1:

 

 

1 uplink B port; 2 downlink A ports

 

Display status

Dual-stack tricolor LEDs on back panel

 

 

 

Input formats

Landscape orientation

2560 x 2048 (8-bit per pixel)

 

Portrait orientation

2048 x 2560 (8-bit per pixel)

 

VGA to XGA/SXGA

640 x 480 to 1024 x 768, 1280 x 1024 displayed in

 

 

both landscape and portrait rotations

 

Screen type

AMLCD (active-matrix liquid crystal display)

 

 

 

Physical

Display size (without stand)

362 mm x 442 mm x 103 mm

 

 

(14.3 in. x 17.4 in. x 4.1 in.)

 

Display weight (without stand)

5.9 kg (13 lb)

 

Mounting options

Desktop stand (standard);

 

 

100-mm VESA mounting (optional)

 

 

 

Power

Adapter

Ault MW122RA1223F52 (CAUTION: Use only the

 

 

power adapter supplied with the display unit.)

 

 

 

24 Dome EX Display

Image 34
Contents Dome EX Display User’s GuidePlanar Systems, Inc. All rights reserved Contents Product Information Symbol explanations Intended useSafety precautions Safety tipsUnpacking and handling tips Preventing fire and injuryCleaning the display Shipping/storing the display Disposal informationDVI cable About the Display System Requirements Display Components Tilt range Height range Orientation modeDisplay Positions Viewing angleStand cable cover Desk Stand FeaturesStand height lock USB hubInstalling the Display Set the DIP Switch on the Dome DX2 Board TipsInstall the Display Controller To install the display controllerConnect the Video and Power Cables To connect the cablesTo enable the display Install the Dome DX Display DriverTo install the driver To change the display propertiesTo set brightness To set the resolution and paletteAuto-orientation To set driver optionsInstall the AX3 Display Driver To configure the displayTo set the display mode manually To adjust the display propertiesTo use a dual-display configuration Appendix Troubleshooting Problem Possible Cause SolutionDome E2 Specification Category Characteristic Item SpecificationReliability Power SupplyEnvironment Dome E3 Specification ModelDome E3 Specification Dome E3 Specification EMI shielding No emission of low-level radiation Temperature Dome E3c Specification Display Mtbf 30,000 hours Backlight Dome E5 Specification Dome E5 Specification Video Modes Connector Ports Details of DIN connectorsLED Status Lights LED a status information after initial power-on Power-up sequence information from LEDLED B status information after initial power-on To set the display resolution Single DesktopTo change the configuration to single desktop Restoring dual headsAuto-Installation System configuration requirementInstallation options Prompting user response during Fastinst.bat To remove the Dome DX driver Display Driver RemovalTo remove the AX3 driver Power Management Grayscale Palette Options Dynamic gray palette Palette options with multiple displaysDesktop icons Nonlinear static gray paletteStatic gray palette Index Using single desktop Regulatory Compliance Canada, European Union, United StatesPage Fax + 358 9 420 EU Declaration of Conformity for Medical Application FCC Compliance Statement Japan AustralianChina KoreaStandard Warranty Return Procedure Standard WarrantySummary Summary Limitations and Exclusions of Dome Displays Limitation of Implied WarrantiesExclusion of Damages Effect of Local LawMedicalsales@planar.com Medicalsupport@planar.com