Planar Dome EX manual To change the configuration to single desktop, Restoring dual heads

Page 41

To change the configuration to single desktop

If you are working on a dual-headed display, you can use the following procedure to change your hardware and software configuration to single desktop.

1Use the InstallShield Wizard to uninstall the existing driver.

2 On the DIP switch, place switch 3 in the ON position.

3Reinstall the display controller. Then attach both displays to the controller.

4Power on the system, and run Setup.exe to install the driver.

5 Set the display resolution.

To get information

Open the Dome tab to retrieve information on the two displays you are using to run single desktop. Information for both left and right panels appears at the bottom of the Dome tab.

Restoring dual heads

To return to dual-headed display, follow the procedure above but place switch 3 on the DIP switch in the OFF position. Then set the display resolution.

Single Desktop 31

Image 41

Contents User’s Guide Dome EX DisplayPlanar Systems, Inc. All rights reserved Contents Product Information Intended use Symbol explanationsSafety tips Safety precautionsPreventing fire and injury Unpacking and handling tipsCleaning the display Disposal information Shipping/storing the displayDVI cable About the Display System Requirements Display Components Display Positions Orientation modeTilt range Height range Viewing angleStand height lock Desk Stand FeaturesStand cable cover USB hubInstalling the Display Tips Set the DIP Switch on the Dome DX2 BoardTo install the display controller Install the Display ControllerTo connect the cables Connect the Video and Power CablesTo install the driver Install the Dome DX Display DriverTo enable the display To change the display propertiesAuto-orientation To set the resolution and paletteTo set brightness To set driver optionsTo configure the display Install the AX3 Display DriverTo use a dual-display configuration To adjust the display propertiesTo set the display mode manually Appendix Problem Possible Cause Solution TroubleshootingCategory Characteristic Item Specification Dome E2 SpecificationEnvironment Power SupplyReliability Model Dome E3 SpecificationDome E3 Specification Dome E3 Specification EMI shielding No emission of low-level radiation Temperature Dome E3c Specification Display Mtbf 30,000 hours Backlight Dome E5 Specification Dome E5 Specification Video Modes Details of DIN connectors Connector PortsLED Status Lights LED B status information after initial power-on Power-up sequence information from LEDLED a status information after initial power-on Single Desktop To set the display resolutionRestoring dual heads To change the configuration to single desktopSystem configuration requirement Auto-InstallationInstallation options Prompting user response during Fastinst.bat To remove the AX3 driver Display Driver RemovalTo remove the Dome DX driver Power Management Grayscale Palette Options Desktop icons Palette options with multiple displaysDynamic gray palette Nonlinear static gray paletteStatic gray palette Index Using single desktop Canada, European Union, United States Regulatory CompliancePage Fax + 358 9 420 EU Declaration of Conformity for Medical Application FCC Compliance Statement China AustralianJapan KoreaSummary Standard WarrantyStandard Warranty Return Procedure Limitation of Implied Warranties Summary Limitations and Exclusions of Dome DisplaysEffect of Local Law Exclusion of DamagesMedicalsales@planar.com Medicalsupport@planar.com