Planar Dome EX manual Grayscale Palette Options

Page 48

Grayscale Palette Options

The Dome DX2 display controller supports different palette options on Windows systems. In the Palette Options field of the Dome tab, use the pull-down menu to select a palette. Then click Apply or OK.

Dome palette options must coordinate with the primary display. All flat panels must be set to either palette devices or non-palette devices, as shown in this table.

Palette Device	Non-Palette Device

Dynamic gray	•	Nonlinear static gray
	•	Static gray

All Dome display controllers that support multiple displays also support differing palette options on multiple screens attached to the same controller. See the assignment of values on the grayscale palettes below.

Assignment of values on the grayscale palettes

38 Dome EX Display

Image 48

Contents Dome EX Display User’s GuidePlanar Systems, Inc. All rights reserved Contents Product Information Symbol explanations Intended useSafety precautions Safety tipsUnpacking and handling tips Preventing fire and injuryCleaning the display Shipping/storing the display Disposal informationDVI cable About the Display System Requirements Display Components Orientation mode Display PositionsTilt range Height range Viewing angleDesk Stand Features Stand height lockStand cable cover USB hubInstalling the Display Set the DIP Switch on the Dome DX2 Board TipsInstall the Display Controller To install the display controllerConnect the Video and Power Cables To connect the cablesInstall the Dome DX Display Driver To install the driverTo enable the display To change the display propertiesTo set the resolution and palette Auto-orientationTo set brightness To set driver optionsInstall the AX3 Display Driver To configure the displayTo adjust the display properties To set the display mode manuallyTo use a dual-display configuration Appendix Troubleshooting Problem Possible Cause SolutionDome E2 Specification Category Characteristic Item SpecificationPower Supply ReliabilityEnvironment Dome E3 Specification ModelDome E3 Specification Dome E3 Specification EMI shielding No emission of low-level radiation Temperature Dome E3c Specification Display Mtbf 30,000 hours Backlight Dome E5 Specification Dome E5 Specification Video Modes Connector Ports Details of DIN connectorsLED Status Lights Power-up sequence information from LED LED a status information after initial power-onLED B status information after initial power-on To set the display resolution Single DesktopTo change the configuration to single desktop Restoring dual headsAuto-Installation System configuration requirementInstallation options Prompting user response during Fastinst.bat Display Driver Removal To remove the Dome DX driverTo remove the AX3 driver Power Management Grayscale Palette Options Palette options with multiple displays Desktop iconsDynamic gray palette Nonlinear static gray paletteStatic gray palette Index Using single desktop Regulatory Compliance Canada, European Union, United StatesPage Fax + 358 9 420 EU Declaration of Conformity for Medical Application FCC Compliance Statement Australian ChinaJapan KoreaStandard Warranty Standard Warranty Return ProcedureSummary Summary Limitations and Exclusions of Dome Displays Limitation of Implied WarrantiesExclusion of Damages Effect of Local LawMedicalsales@planar.com Medicalsupport@planar.com