InFocus XS1 manual Information menu, Current System, Status

Page 49

INFORMATION menu

This menu shows you the current operating status of the projector.

Some picture adjustments are available only when certain input sources are in use. Unavailable adjustments are not shown on the screen.

FUNCTION	DESCRIPTION

	Source
	Shows the current signal source.
	Preset Mode
	Shows the selected mode in the PICTURE menu.
Current System	Resolution
Status	Shows the native resolution of the input signal.
	Color System
	Shows input system format, NTSC, PAL, SECAM, or RGB.
	Equivalent Lamp Hour
	Displays the number of hours the lamp has been used.

Operation 49

Image 49

Contents Reference Guide Table of contents Introduction Projector featuresShipping contents Front/upper side Rear/lower side Projector exterior viewProjector Controls and functionsDigital Zoom buttons + Remote controlKeystone buttons Up FreezeReplacing the remote control battery Remote control effective rangePositioning your projector Set Rear Ceiling in the System Setup BasicChoosing a location Front TableObtaining a preferred projected image size Page Screen diagonal Connecting a computer Connecting a computer or monitorConnection Iii Connecting a monitor Connecting audio Connecting Video source devicesBest video quality Better video qualityConnecting a DVI source device Connection To connect the projector to a Component Video source device Connecting a Component Video source deviceTo connect the projector to an S-Video source device Connecting an S-Video source deviceTo connect the projector to a composite Video source device Connecting a composite Video source deviceStarting up the projector OperationSub-menu Using the menusUtilizing the password function Using a security cable lockSecuring the projector Removing the control keypad on the projectorIf you forget the password Setting a passwordHighlight Change Security Settings and press Mode/Enter Changing the password Entering the password recall procedureDisabling the password function DVI-A DVI-D Switching input signalChanging Color Space Creating your own startup screenAdjusting the projection angle Adjusting the projected imageAuto-adjusting the image Fine-tuning the image clarityCorrecting keystone Page About the aspect ratio Selecting the aspect ratioPicture modes for different types of signals Selecting a picture modePC/DVI-A/DVI-D Signal Input YPbPr/S-Video/Video/HDCP Signal InputSetting the User 1/User 2 mode Using Wall ColorFine-tuning the image quality in user modes Selecting a color temperature Adjusting BrilliantColorAbout color temperatures 3D Color ManagementPress Mode/Enter and the 3D Color Management page displays Go to the System Setup Basic Setting the presentation timerPresentation Timer menu and press Mode Enter to display the Presentation TimerLocking control keys To cancel the timer, perform the following stepsFreezing the image Operating in a high altitude environment Hiding the imageAdjusting the sound level Adjusting the soundPersonalizing the projector menu display Muting the soundShutting down the projector Menu system Menu operationAdvanced BasicSource menu Display menuPicture menu System Setup Basic menu System Setup Advanced menu Current System Information menuStatus Care of the projector MaintenanceLamp information Setting Lamp Mode as EconomicGetting to know the lamp hour Extending lamp lifeStatus Message Timing of replacing the lampReplacing the lamp Page Tighten the screw that secures the lamp Resetting the lamp timerIndicators Remote control does not work TroubleshootingProjector does not turn on No pictureProjector specifications SpecificationsTiming chart DimensionsHorizontal Vertical Pixel Resolution Frequency Mode KHz MHz Supported timing for PC including DVI-D inputSupported timing for Component-YPbPrinput Signal Format Horizontal Vertical Frequency Frequency kHzSupported timing for Video and S-Video inputs Copyright Copyright informationDisclaimer