InFocus XS1 manual Timing of replacing the lamp, Status Message

Timing of replacing the lamp

When the Lamp indicator lights up red or a message appears suggesting it is time to replace the lamp, please install a new lamp or consult your dealer. An old lamp may cause a malfunction in the projector and in some instances the lamp may explode.

CAUTION

The Lamp indicator light and Temperature warning light will light up if the lamp becomes too hot. Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator still lights up after turning the power back on, please contact your dealer. See "Indicators" on page 56 for details.

The following Lamp warning displays will remind you to change the lamp.

Status	Message
The lamp has been in operation for 3000	Notice
hours. Install a new lamp for optimal
performance. If the projector is normally run	Order Replacement Lamp
with "Economic Mode" selected (See "Lamp
Mode (Normal)" on page 48), you may	Lamp > 3000 Hours
continue to operate the projector until the
3950 hour lamp warning appears.	OK
The lamp has been in operation for 3950	Notice
hours. A new lamp should be fitted to avoid
the inconvenience when the projector runs	Replace Lamp Soon
out of lamp time.
	Lamp > 3950 Hours
	OK
The lamp has been in operation for 4000
hours.	Notice
It is strongly recommended that you replace	Replace Lamp Now
the lamp at this age. The lamp is a	Lamp > 4000 Hours
consumable item. The lamp brightness	Lamp usage time exceeded
diminishes with use. This is normal lamp
behavior. You can replace the lamp whenever	OK
you notice that the brightness level has
significantly diminished. If the lamp is not
replaced beforehand, it must be replaced
after 3000 hours usage.
The lamp MUST be replaced before the	Notice
projector will operate normally.
	Out of Lamp Usage Time
	Replace lamp (refer to reference guide)
	Then reset lamp timer
	OK

52 Maintenance