InFocus XS1 manual Tighten the screw that secures the lamp, Resetting the lamp timer

Page 55

7.Tighten the screw that secures the lamp.

CAUTION

Loose screw may cause a bad connection, which could result in malfunction.

Do not over tighten the screw.

8.Ensure the handle is fully laid flat and locked in place.

9.Replace the lamp cover on the projector.

10.Use a coin to turn the screw clockwise until the lamp cover is secured.

CAUTION

Loose screw may cause a bad connection, which could result in malfunction.

Do not over tighten the screw.

11.Restart the projector.

Resetting the lamp timer

12.After the startup logo, open the On- Screen Display (OSD) menu. Go to the SYSTEM SETUP: Advanced > Lamp Settings menu. Press Mode/Enter. The Lamp Settings page displays. Highlight Reset Lamp Timer. A warning message displays asking if you want to reset the lamp timer. Highlight Reset and press Mode/Enter. The lamp time will be reset to '0'.

CAUTION

Do not reset if the lamp is not new or replaced as this could cause damage.

Notice

Reset Lamp Timer?

Reset Cancel

Maintenance 55

Image 55
Contents Reference Guide Table of contents Introduction Projector featuresShipping contents Front/upper side Rear/lower side Projector exterior viewProjector Controls and functionsFreeze Remote controlDigital Zoom buttons + Keystone buttons UpReplacing the remote control battery Remote control effective rangeFront Table Set Rear Ceiling in the System Setup BasicPositioning your projector Choosing a locationObtaining a preferred projected image size Page Screen diagonal Connecting a computer Connecting a computer or monitorConnection Iii Connecting a monitor Better video quality Connecting Video source devicesConnecting audio Best video qualityConnecting a DVI source device Connection To connect the projector to a Component Video source device Connecting a Component Video source deviceTo connect the projector to an S-Video source device Connecting an S-Video source deviceTo connect the projector to a composite Video source device Connecting a composite Video source deviceStarting up the projector OperationSub-menu Using the menusRemoving the control keypad on the projector Using a security cable lockUtilizing the password function Securing the projectorIf you forget the password Setting a passwordHighlight Change Security Settings and press Mode/Enter Changing the password Entering the password recall procedureDisabling the password function DVI-A DVI-D Switching input signalChanging Color Space Creating your own startup screenFine-tuning the image clarity Adjusting the projected imageAdjusting the projection angle Auto-adjusting the imageCorrecting keystone Page About the aspect ratio Selecting the aspect ratioYPbPr/S-Video/Video/HDCP Signal Input Selecting a picture modePicture modes for different types of signals PC/DVI-A/DVI-D Signal InputSetting the User 1/User 2 mode Using Wall ColorFine-tuning the image quality in user modes 3D Color Management Adjusting BrilliantColorSelecting a color temperature About color temperaturesPress Mode/Enter and the 3D Color Management page displays Enter to display the Presentation Timer Setting the presentation timerGo to the System Setup Basic Presentation Timer menu and press ModeLocking control keys To cancel the timer, perform the following stepsFreezing the image Operating in a high altitude environment Hiding the imageMuting the sound Adjusting the soundAdjusting the sound level Personalizing the projector menu displayShutting down the projector Menu system Menu operationAdvanced BasicSource menu Display menuPicture menu System Setup Basic menu System Setup Advanced menu Current System Information menuStatus Care of the projector MaintenanceExtending lamp life Setting Lamp Mode as EconomicLamp information Getting to know the lamp hourStatus Message Timing of replacing the lampReplacing the lamp Page Tighten the screw that secures the lamp Resetting the lamp timerIndicators No picture TroubleshootingRemote control does not work Projector does not turn onProjector specifications SpecificationsSupported timing for PC including DVI-D input DimensionsTiming chart Horizontal Vertical Pixel Resolution Frequency Mode KHz MHzSupported timing for Component-YPbPrinput Signal Format Horizontal Vertical Frequency Frequency kHzSupported timing for Video and S-Video inputs Copyright Copyright informationDisclaimer