InFocus XS1 manual

Page 54

4.Loosen the screw that secures the lamp.

5.Lift the handle so that it stands up. Use the handle to slowly pull the lamp out of the projector.

CAUTION

•Pulling it too quickly may cause the lamp to break and scatter broken glass in the projector.

•Do not place the lamp in locations where water might splash on it, children can reach it, or near flammable materials.

•Do not insert your hands into the projector after the lamp is removed. If you touch the optical components inside, it could cause color unevenness and distortion of the projected images.

6.As shown in the figure, lower the new lamp first into the connector on the projector and align the two holes on the projector.

54 Maintenance

Image 54

Contents Reference Guide Table of contents Projector features IntroductionShipping contents Projector exterior view Front/upper side Rear/lower sideControls and functions ProjectorKeystone buttons Up Remote controlDigital Zoom buttons + FreezeRemote control effective range Replacing the remote control batteryChoosing a location Set Rear Ceiling in the System Setup BasicPositioning your projector Front TableObtaining a preferred projected image size Page Screen diagonal Connecting a computer or monitor Connecting a computerConnection Iii Connecting a monitor Best video quality Connecting Video source devicesConnecting audio Better video qualityConnecting a DVI source device Connection Connecting a Component Video source device To connect the projector to a Component Video source deviceConnecting an S-Video source device To connect the projector to an S-Video source deviceConnecting a composite Video source device To connect the projector to a composite Video source deviceOperation Starting up the projectorUsing the menus Sub-menuSecuring the projector Using a security cable lockUtilizing the password function Removing the control keypad on the projectorSetting a password If you forget the passwordHighlight Change Security Settings and press Mode/Enter Entering the password recall procedure Changing the passwordDisabling the password function Switching input signal DVI-A DVI-DCreating your own startup screen Changing Color SpaceAuto-adjusting the image Adjusting the projected imageAdjusting the projection angle Fine-tuning the image clarityCorrecting keystone Page Selecting the aspect ratio About the aspect ratioPC/DVI-A/DVI-D Signal Input Selecting a picture modePicture modes for different types of signals YPbPr/S-Video/Video/HDCP Signal InputUsing Wall Color Setting the User 1/User 2 modeFine-tuning the image quality in user modes About color temperatures Adjusting BrilliantColorSelecting a color temperature 3D Color ManagementPress Mode/Enter and the 3D Color Management page displays Presentation Timer menu and press Mode Setting the presentation timerGo to the System Setup Basic Enter to display the Presentation TimerTo cancel the timer, perform the following steps Locking control keysFreezing the image Hiding the image Operating in a high altitude environmentPersonalizing the projector menu display Adjusting the soundAdjusting the sound level Muting the soundShutting down the projector Menu operation Menu systemBasic AdvancedDisplay menu Source menuPicture menu System Setup Basic menu System Setup Advanced menu Information menu Current SystemStatus Maintenance Care of the projectorGetting to know the lamp hour Setting Lamp Mode as EconomicLamp information Extending lamp lifeTiming of replacing the lamp Status MessageReplacing the lamp Page Resetting the lamp timer Tighten the screw that secures the lampIndicators Projector does not turn on TroubleshootingRemote control does not work No pictureSpecifications Projector specificationsHorizontal Vertical Pixel Resolution Frequency Mode KHz MHz DimensionsTiming chart Supported timing for PC including DVI-D inputSignal Format Horizontal Vertical Frequency Frequency kHz Supported timing for Component-YPbPrinputSupported timing for Video and S-Video inputs Copyright information CopyrightDisclaimer