OPERATION
!AC LINE CORD INPUT - The projector requires AC power of 100 to 240 VAC, 50 to 60 Hz (11.5 amps @ 100 VAC, 5.5 amps @ 220 VAC). Always use the line cord that is supplied with the
! WARNING !
Do not attempt operation if the AC supply is not within the specified voltage and power range.
STATUS/POWER LEDS - Two LEDs (light emitting diodes) located in the lower right corner of the rear connector panel indicate projector “Status” (top) and “Power” (bottom). During normal operation, the “Power” light is steady green and the “Status” light flashes green each time a key is pressed or when the projector receives a serial command. Use the following as a guide:
Reading the Status LEDs
NOTE: A steady red power light accompanied by a coded pattern of red and yellow flashes from the status light indicates an internal system error. Consult the rear LCD display for an explana- tion, and see 3.8, Error Conditions. Should the problem persist, contact your Runco dealer.
REMOTE WIRED KEYPAD CONNECTOR
LCD STATUS DISPLAY - Visual feedback for monitoring projector activities and status.
INFRARED SENSORS - The infrared (IR) sensors on the front and rear of the projector receive infrared signals from the IR keypad for remote control of projector functions. For proper opera- tion make sure that these sensors are not blocked.
HARD RESET - Emergency access for powering down the projector in the event of a system failure. Insert a pen point or small screwdriver.