Runco VX-4C, VX-6C manual Rear Panel

Rear Panel

1 5

12V FUSE

		RGB VIDEO OUTPUT						VIDEO INPUTS
RS-232 IN	V	H	B	G	R	PASS THROUGH	Y	Pr	Pb S-VIDEO COMPOSITE

MASK SCREEN

12V TRIGGER

RUNCO INTERNATIONAL

UNION CITY, CA

AC 120V 60Hz, 15W

MADE IN USA

2 3 4 6 7 8 9 10 11 12 13

1.12v Fuse

This fuse protects the 12v outputs from the MASK and SCREEN jacks. (Screen Fuse: 5mm x 25mm, AGC, 0.5A 250V Fast Acting, 250V, Fast Blow)

2.Mask

This is a 12V output that is used to trigger masking on screens that have that capability. (For use on motorized screens only).

3.Screen

This is a 12V output that is used to trigger the screen to drop. (For use on motorized screens only).

4.RS-232 In

This is for systems using serial (RS-232) to control the VHD Ultra Controller.

5.Reserved for future use.

6.RGB OUTPUT

This is the main output of the VHD Ultra Controller. The RGB Signal goes directly to the VX-4c/VX-6c Projector. If component is used through the pass-through, then only the R (Pr), G(Y) and B(Pb) jacks will be active. Individually, the jacks are: V=vertical sync, H=horizontal sync, B=Blue, G=Green, R=Red.

7.Pass-through

Anything input to this port will by-pass the processing of the VHD Ultra Controller and be sent straight to the VX-4c/VX-6c Projector. This is useful for computer graphics and HDTV signals which do not require process- ing.

8.Component Input

This is the input for component video from sources such as DVD players.

Note: The component output from a DTV decoder or a progressive-scan DVD cannot be used with this port; it must be input to the Pass-through port.

9.S-Video Input

This is the input for S-video from sources such as Satellite receivers, S-VHS VCR’s and DVD players.

6-6