Runco VX-4C, VX-6C Display M. Bank List, Show Adjust Bar, Show Message, IR and Serial Setup Menu

OPERATION

Display M. Bank List

Enter a checkmark if you want to see a scrollable channel list whenever you press Chan from your presentation (note that each channel to be included in the list must also be tagged in the “In Menu” checkbox in the Memory Banks menu). This option also enables on-screen feedback when using the Input key. If you prefer to hide the channel list and input dialog box while switching channels and sources during a presentation, do not enter a checkmark.

NOTE: The Bank List and input dialog box cannot be hidden when a menu is dis played.

Show Adjust Bar

Enter a checkmark to superimpose a small sidebar over the current image whenever an adjustable parameter is selected directly with the keypad. If “Show Adjust Bar” is unchecked, these slidebars can still be accessed, but will be hidden during adjustment.

Show Message

Choose in what way you want to be notified of errors detected in either the incoming signal or projector. Select “Screen” or “All” to see a brief on-screen message or select “RS232” to be see messages via RS232 and RS422 serial communication only. To dis- able error message display, select “Off.”

IR and SERIAL SETUP MENU
			IR and Serial Setup
Use the checkboxes and pull-down lists in the IR and
Serial Setup menu to alter the meth ods or types of
communication to and from the projector. Changes
made to the IR and Serial Setup menu will be saved
when you exit the menu.			Installation Menu
Baud Rate		The baud rate setting determines the speed of communications to and
	1200
		from the projector. By default, the projector baud rate is set to 9600.
	2400	Setting the correct speed is important when you are controlling the
	9600	projector with an external device or another projector via an RS-232 or
		RS-422 port. You must set the projector baud rate at these ports to
	19200
		match the baud rate of the controlling device. If you are unsure about
	38400
		what baud rate to choose, refer to the documentation for the control-
	57600	ling device.
	115200

NOTE: 1) The baud rate setting does not affect the switcher port, which is always 9600 baud.

3-25