Runco VX-4C Installing The Lens, Unplug the projector, Install the lens cap, Loosen 3 screws

INSTALLATION AND SETUP

2.2Installing The Lens

A variety of lenses are available to accommodate different throw distances and specific types of installations. See page 2-10 for details. To change/install a lens, follow the steps below.

NOTES: 1) You will need a 9/64”(3mm or 3.5mm) hex socket ball driver (supplied with projec- tor) or allen wrench for this procedure. 2) “Top” or “bottom” references assume a non-inverted projector, as illustrated. 3) If you are installing a lens, first make sure its Lens Adapter is present on either the lens or projector. Such an adapter/flange secures to the projector in the same man- ner as the flange described below, but accommodates a screw-mount lens.

STEP 1 Turn off the projector, cool, and unplug. Before removing or installing a lens, turn off the projector and allow it to cool for five minutes before unplugging. Make sure that the lens cap is on.

! WARNING	Install Lens Cap
Unplug the projector.
Install the lens cap.

STEP 2 Loosen the 3 lens mount screws

IF FIXED LENS: Use the hex socket ball driver provided with the projector to loosen the 3 lens mount screws that secure the lens flange to the mount-loosen these screws only, do not remove.

Loosen 3 screws

- FIXED LENS -

2-2