Sharp AL-1633, AL-1644 Explanation, 300dpi, Minimum, Short beep, Copies, Upper paper tray*3

USER SETTINGS

Program		Setting codes
	Program name	(factory default setting		Explanation
number
		appears in bold)
19	Offset of paper output	0: OFF	•	When enabled, this function offsets the position
				in the paper output tray of interrupt copy jobs,
	tray	1: ON
				and print jobs when using the printer function.
		1: 300dpi	•	The copy resolution in auto and text mode is
23	Resolution in			normally 300 dpi. If high-quality copies are
	Auto/Text mode	2: 600dpi		preferred, use this setting to change the
				resolution to 600 dpi.
			•	Use this setting to select whether or not
				holding down a key causes repeated input of
		0: OFF		the key. For keys that normally cause a set
25	Key auto repeat			value to increase when held down (for
		1: ON
				example, holding down the [ZOOM] key ( ,
				)), this program can be used to have the set
				value not change when the key is held down.
		1: Minimum	•	Use this setting to select how long a key must
		(current response
		speed)		be pressed for the input to be accepted. By
26	Key press time	2: 0.5 sec.		selecting a longer time, you can prevent
		3: 1.0 sec.		settings from being changed by the accidental
		4: 1.5 sec.		pressing of a key.
		5: 2.0 sec.
		1: Short beep
27	Audible signals volume	2: Long beep	•	This sets the volume of beep signals. (p.40)
		3: OFF
28	Base setting beep	0: OFF	•	Use this to sound a beep when a base setting
	signal	1: ON		is selected. (p.40)
29	Number of copies limit	1: 99 copies	•	Use this setting to select 99 or 999 for the
		2: 999 copies		maximum number of copies.
			•	When this function is enabled, printing in
		0: OFF		printer mode will automatically continue using
30	Use close paper size			a different size of paper if the specified size of
		1: ON
				paper runs out in all trays. This feature does
				not function in copy mode.
		1: Upper paper tray*3	•	Use this program to select a default tray. This
31	Default tray setting	2: Lower paper tray*3		tray is automatically selected each time the
		5: Bypass tray*3		power is turned on or each time the machine
				reverts to the initial settings.
	Default exposure	1: AUTO	•	Use this program to set "AUTO", "TEXT", or
32		2: TEXT
	mode			"PHOTO" as the default exposure mode.
		3: PHOTO
*3 AL-1633 is as follows:
1: Paper tray (factory default), 5: Bypass tray

4

39