Sigma SQM-160 manual Warranty Information, Limitation of Warranty, Return Policy

Page 3

Warranty Information

This Sigma Instruments product is warranted against defects in material and workmanship for a period of 1 year from the date of shipment, when used in accordance with the instructions in this manual. During the warranty period, Sigma Instruments will, at its option, either repair or replace products that prove to be defective.

Limitation of Warranty

Defects from, or repairs necessitated by, misuse or alteration of the product, or any cause other than defective materials or workmanship are not covered by this warranty.

NO OTHER WARRANTIES ARE EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. UNDER NO CIRCUMSTANCES SHALL SIGMA INSTRUMENTS BE LIABLE FOR CONSEQUENTIAL OR OTHER DAMAGES RESULTING FROM A BREACH OF THIS LIMITED WARRANTY, OR OTHERWISE.

Return Policy

The purchaser may return this product in like new condition within 30 days after shipment for any reason. In case of return, purchaser is liable and responsible for all freight charges in both directions.

Image 3
Contents SQM-160 Safety Symbols Safety InformationWarranty Information Limitation of WarrantyReturn Policy Chapter MonComm Software Table of Contents Chapter Quick StartChapter Operation Chapter OptionsAppendix Chapter MaintenanceChapter Quick Start Introduction InstallationFront Panel Controls Chapter Quick StartRear Panel Connections Chapter Quick Start Rear PanelSystem Components Chapter Quick Start System ConnectionsChapter Quick Start Film Setup Chapter Quick Start Depositing a Film Menu Selection Chapter Operation IntroductionChapter Operation Film Parameters Setup Description Range Default Units Film Selection Film Parameters Menu Sub-MenuDisplay Chapter Operation System Parameters Setup System Parameters Menu Sub-Menu Timebase SIM Mode FRQ Disp Rate RES Ratefilt Baudrate EtchFMIN/MAX Freq MIN Freq MAX Display xTOOLINGChapter Operation Sensor Selection Chapter Operation Sensor Min/Max Frequency Chapter Operation Sensor Tooling Crystal Life Display Chapter Operation Rate/Thickness or Frequency DisplaySimulate Mode Chapter Operation Zero ThicknessShutter Operation Chapter Options Introduction Analog Output Card Chapter Options Four Sensor CardRun MonComm Chapter MonComm Software IntroductionChapter MonComm Software Add and Delete Films To add a new film to the Films ListTo delete a film from the Films List To download the films in the Download List Chapter MonComm Software Download FilmsTo add or replace a film in the Download List To remove a film from the Download ListChapter MonComm Software Graph Data Save Data To Adjust the Graph’s ScopeChapter MonComm Software Edit System Parameters Load DefaultsFuse Replacement Chapter Maintenance IntroductionAppendix Material Parameters Appendix Specifications Relay I/O Connector Rear View Pins Type DescriptionAppendix O Connections Product Model SQM-160 Product Options All Options SafetyAppendix Declaration of Conformity Declares that the product