Chapter 2 | Operation |
2.3System Parameters Setup
The System Parameters Menu sets values that pertain to the overall functioning of the
1.Press Program
to enter program mode.
2.Press Prev
to enter the System Parameters Menu
3.Use Next 
and Prev
to move through the system parameters.
4.Use the Control Knob to adjust the parameter value shown in Display2 to the desired setting.
5.Press Clear to abandon the change and return to the original setting.
6.Depress the Control Knob to save the displayed value, or press Next 
to exit without saving the value. (Pressing either one will take you to the next material parameter.)
7.Press Program
to exit the System Parameters Menu and return to normal mode.
Notes:
1.Refer to the section on Sensor Tooling for instructions on setting xTOOLING.
2.Refer to the section on Sensor Min/Max for instructions on setting FMIN/FMAX.
3.Refer to the Options Chapter for instructions on setting R/T BNDS for the Analog Output Card