Sigma SQM-160 Chapter MonComm Software Add and Delete Films, To add a new film to the Films List

Page 26

Chapter 4

MonComm Software

4.3Add and Delete Films

To add a new film to the Films List:

1.Click the New Film button.

2.A film named NewFilm# will be added to the end of the films list.

3.Click on this film to highlight it.

4.Change the name of the film - up to eight characters are allowed.

5.Select the material for the film from the Material combo box.

6.The density and the Z-factor for the material will be automatically changed to that of selected material. Both parameters can be edited if desired.

7.Change the tooling for the film to the desired percentage.

8.Set the thickness setpoint, final thickness, and the time setpoint to the desired values for the film.

9.Select the channels to enable for the film. A checked box indicates the channel is enabled for the film. If only two channels are available, then enabling a channel above 2 will have no effect.

To delete a film from the Films List:

1.Highlight the film to be deleted by clicking it once in the Films list box.

2.Click on the Delete Film button.

4-2

Image 26
Contents SQM-160 Safety Information Safety SymbolsReturn Policy Warranty InformationLimitation of Warranty Chapter Options Table of Contents Chapter Quick StartChapter Operation Chapter MonComm SoftwareChapter Maintenance AppendixInstallation Chapter Quick Start IntroductionChapter Quick Start Front Panel ControlsChapter Quick Start Rear Panel Rear Panel ConnectionsChapter Quick Start System Connections System ComponentsChapter Quick Start Film Setup Chapter Quick Start Depositing a Film Chapter Operation Introduction Menu SelectionChapter Operation Film Parameters Setup Display Description Range Default UnitsFilm Selection Film Parameters Menu Sub-Menu Chapter Operation System Parameters Setup Timebase SIM Mode FRQ Disp Rate RES Ratefilt Baudrate Etch System Parameters Menu Sub-MenuDisplay xTOOLING FMIN/MAX Freq MIN Freq MAXChapter Operation Sensor Selection Chapter Operation Sensor Min/Max Frequency Chapter Operation Sensor Tooling Chapter Operation Rate/Thickness or Frequency Display Crystal Life DisplayShutter Operation Simulate ModeChapter Operation Zero Thickness Chapter Options Introduction Chapter Options Four Sensor Card Analog Output CardChapter MonComm Software Introduction Run MonCommTo delete a film from the Films List Chapter MonComm Software Add and Delete FilmsTo add a new film to the Films List To remove a film from the Download List Chapter MonComm Software Download FilmsTo add or replace a film in the Download List To download the films in the Download ListChapter MonComm Software Graph Data To Adjust the Graph’s Scope Save DataLoad Defaults Chapter MonComm Software Edit System ParametersChapter Maintenance Introduction Fuse ReplacementAppendix Material Parameters Appendix Specifications Appendix O Connections Relay I/O Connector Rear ViewPins Type Description Declares that the product SafetyAppendix Declaration of Conformity Product Model SQM-160 Product Options All Options