Chapter 2 | Operation |
The diagram and table below detail the parameters available in the Film Parameters Menu:
Film Selection Film Parameters Menu |
|
Program
Film1
.
.
.
.
.
.
Film9
- DENSITY |
- TOOLING |
- |
- FINL THK |
- THK SET |
- TIME SET |
- SENS AVG |
-1
-2
- 3
Sensors 3 to 6 show only if the
. four sensor
. option card is - 6 iinstalled.
Display
DENSITY
TOOLING
Description | Range | Default | Units |
Density of the material being | 0.5 – 99.99 | 1.00 | gm/cc |
deposited. |
|
|
|
Overall tooling Factor for this film. | 10 – 399 | 100 | % |
See the Sensor Tooling section of |
|
|
|
this chapter for information on setting tooling values.
Z-FACTOR
FINL THK
0.10 – 10.00 | 1.0 |
| |
deposited. |
|
|
|
Desired Final Thickness of | 0.000 – 99.99 | 0.500 | KÅ |
deposited material. Lights Final Thk |
|
|
|
LED. Zero is disabled. |
|
|
|
THK SET Thickness value that closes the 0.000 – 99.99 0KÅ Thickness Setpoint relay and lights
Thk SP LED. Zero is disabled.
TIME SET
SENS AVG
Elapsed time that closes the Timer | 0:00 – 99:59 | 0 | Sec |
Setpoint relay and lights Time SP |
|
|
|
LED. Zero is disabled. |
|
|
|
Enable/disable crystals for this film. | Enabled/ | Ch1 |
|
See the Sensor Selection section of | Disabled | Enabled |
|
this chapter for more information. |
|
|
|