Canopy T1/E1 Multiplexer | September 2004 |
| T1/E1 Multiplexer FPGA Version 3.4 |
WARNING!
Disconnect power before proceeding.
Follow this procedure to connect the supplied AC adapter (+3.3 v DC power source).
Procedure 3: Connecting the AC adapter (+3.3 v DC power source)
1.Connect the AC adapter to a surge suppression device that meets the standard specified under Power Supply Unit on Page 27.
2.Connect the surge suppression device to the building AC power source.
3.Connect the AC adapter to the DC IN port on the rear of the Canopy T1/E1 Multiplexer.
end of procedure
Follow this procedure to connect the to an external −48 v DC power source.
Procedure 4: Connecting the −48 v DC power source
CAUTION!
Ensure correct polarity before connecting external DC supply to Canopy
T1/E1 Multiplexer.
1.Connect the power cables to the terminal strip ensuring the correct polarity is maintained.
2.Once the Canopy T1/E1 Multiplexer is mounted in its desired configuration, connect the supplied terminal strip to the back of the unit. Do this by slowly pushing the terminal strip into the connector on the back of the Canopy T1/E1 Multiplexer.
Issue 3 | Page 31 of 73 |