Motorola T1/E1 manual Configure Timing, Procedure 13 Configuring timing using the CLI

Canopy T1/E1 Multiplexer	September 2004
	T1/E1 Multiplexer FPGA Version 3.4

2.4.6Configure Timing

Before the timing may be configured, you need to determine the network timing scheme to be used. You also need to identify the master and slave devices for the end-user PBX equipment.

	Procedure 13: Configuring timing using the CLI
Action	Steps
Log in	Press Enter.
	At the username prompt, enter admin.
	At the password prompt, enter password.
Set master clock	NOTE: This is the master clock reference for all four T1/E1 lines.
reference line	The default setting is T1/E1 Port 1.
	Enter set master clock reference line [1/2/3/4]
	where
	[1/2/3/4] represents T1/E1 ports 1 through 4.
	RESULT: The system responds
	Clk ref line; [1,2,3,4]
Set backup clock	NOTE: This is the optional backup clock reference for all four T1/E1 lines. The
reference line	backup clock reference becomes active only when the master clock reference
	line is unavailable. The default setting is T1/E1 Port 2.
	Enter set secondary clock reference line [1/2/3/4]
	where
	[1/2/3/4] represents T1/E1 ports 1 through 4.
	RESULT: The system responds
	Backup clk ref line; [1/2/3/4]

Issue 3 Page 44 of 73