Motorola T1/E1 manual Regulatory Compliance Information

Canopy T1/E1 Multiplexer	September 2004
	T1/E1 Multiplexer FPGA Version 3.4
Desired Action	Syntax, Response, and Description
Get FPGA Revision Enter get fpga revision

The system responds

FPGA revision is: x.y.z

Get the revision (version number) of the Canopy T1/E1 FPGA. The

FPGA controls the T1 parameters.

4.2REGULATORY COMPLIANCE INFORMATION

This section contains information regarding regulatory compliance with the Federal Communication Commission, Department of Communications and the European Telecommunications Standards Institute applies to the Canopy BH radio link.

4.2.1Federal Communication Commission Declaration of Conformity Statement

This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and radiates radio-frequency energy, and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

WARNING!

The Part 15 radio device operates on a non-interference basis with the other devices operating at this frequency. Any changes or modification to said product not expressly approved by Motorola Canopy could void the user’s authority to operate this device.

Issue 3 Page 71 of 73