Motorola Invoking a T1/E1 Loopback using the CLI, Invoking a T1/E1 Loopback Using the EMS

Canopy T1/E1 Multiplexer	September 2004
	T1/E1 Multiplexer FPGA Version 3.4

3.4.1Invoking a T1/E1 Loopback using the CLI

Follow the steps below to invoke a T1/E1 Loopback from the CLI.

Procedure 27: Invoking a T1/E1 loopback using the CLI

	Action			Steps
Log in		Press Enter.
		At the username prompt, enter admin.
		At the password prompt, enter password.
Set T1/E1 into Loopback		Enter set line loopback [1/2/3/4] [on/off]
Mode		where
		[1/2/3/4] represents T1/E1 ports 1 through 4.
		on will enable T1/E1 loopback.
		off will remove the T1/E1 loopback.
		The system responds
		Line [1/2/3/4] loopback is: [on/off]
		Enter lo.
Log off
		RESULT: The system responds goodbye.
			end of procedure

3.4.2Invoking a T1/E1 Loopback Using the EMS

Procedure 28: Invoking a T1/E1 loopback using the EMS

Use this procedure to invoke a T1/E1 Loopback from the EMS.

1.Select the Test→Loopback menu option. RESULT: The Loopback Test dialogue box opens.

2.Select the target T1/E1 Channel by clicking on the appropriate tab.

3.Use the On or Off radio button to invoke or remove the T1/E1 loopback. RESULT: The Loopback is immediately invoked or removed.

end of procedure

Issue 3 Page 58 of 73