Canopy T1/E1 Multiplexer | September 2004 |
| T1/E1 Multiplexer FPGA Version 3.4 |
1UNDERSTANDING THE CANOPY T1/E1 MULTIPLEXER
1.1USING THIS USER GUIDE
This guide should be used with Canopy T1/E1 Multiplexer FPGA Version 3.4. The audience for this document includes system operators, network administrators, and equipment installers.
1.1.1New in This Issue
Issue 3 of this user guide is published to state the requirement that an external surge suppression device must be used with the AC adapter supplied by Canopy for the T1/E1 Multiplexer, and to specify the recommended standard. The following elements of this document are affected:
◦Introduction to Canopy T1/E1 Multiplexer on Page 9
◦beneath Figure 3 on Page 12
◦Power Adapters on Page 18
◦Lightning Protection on Page 27
◦Power Supply Unit on Page 27
◦Procedure 3 on Page 31
Also in Issue 3, Preparing for Installation and Setup on Page 28 clarifies how Ethernet cables must be selected.
1.1.2Using the Latest Information
When Canopy T1/E1 Multiplexers are shipped, the latest issue of this document is included on
You can distinguish the latest information by the issue number on the cover and in page footers. The above section, New in This Issue, lists the significant changes that were made to the document since the previous issue. Check that section before you proceed to the information for which you are visiting the document.
1.1.3Searching This User Guide
To search this document, look in
◦the Table of Contents for the topic.
◦the Adobe Reader® search capability for keywords that apply.1
1.1.4Interpreting Typeface and Other Conventions
This document employs distinctive fonts to indicate the type of information, as described in Table 1.
1Reader is a registered trademark of Adobe Systems, Incorporated.
Issue 3 | Page 7 of 73 |