Canopy T1/E1 Multiplexer | September 2004 |
| T1/E1 Multiplexer FPGA Version 3.4 |
2.4.5Configure Ports
Procedure 10: Configuring the Ethernet ports using the CLI
Perform this procedure to configure the Ethernet ports using the CLI manager.
NOTE: Both Ethernet ports operate at 100 Mbps Full Duplex. They will not operate at 10 Mbps or at half duplex.
Action
Log in
Set
Set
Log off
Steps
Press Enter.
At the username prompt, enter admin.
At the password prompt, enter password.
Enter set canopy port auto negotiation [on/off]
where
on enables auto negotiation at 100 Mbps Full Duplex (as default). off forces the port to 100 Mbps Full Duplex without auto negotiation.
RESULT: The system responds
Canopy port
Enter set lan port auto negotiation [on/off]
where
on enables auto negotiation at 100 Mbps Full Duplex (as default). off forces the port to 100 Mbps Full Duplex without auto negotiation.
RESULT: The system responds
LAN port
Enter lo.
RESULT: The system responds goodbye.
end of procedure 
Issue 3 | Page 39 of 73 |