Canopy T1/E1 Multiplexer | September 2004 |
| T1/E1 Multiplexer FPGA Version 3.4 |
10.At the username prompt, enter admin.
11.At the password prompt, enter your new password.
end of procedure 
2.4.3Select Line Type T1 or E1
Procedure 8: Selecting line type T1 or E1 using the CLI
Follow this procedure to select the appropriate line type using the CLI manager.
Action | Steps |
Log in | Press Enter. |
| At the username prompt, enter admin. |
| At the password prompt, enter password. |
|
|
Get line type | Enter get line type. |
| RESULT: The system returns the line type for all four |
| ports, as in the following example: |
| Line type [T1/E1] |
Set line type | Enter set line type [T1/E1] |
| where |
| T1 sets the line type to T1 for all 4 ports. |
| E1 sets the line type to E1 for all 4 ports. |
| RESULT: The system acknowledges the new setting for |
| line type for all four ports, as in the following example: |
| Line type [T1/E1] |
|
|
Reset system | Enter reset. |
| RESULT: The system responds Resetting, then |
| immediately resets both Ethernet Interfaces and all 4 |
| T1/E1 interfaces without asking for a confirmation. |
CAUTION!
The previously configured line type remains in effect until the system is reset. Therefore, this step should always be followed by a reset.
end of procedure 
Issue 3 | Page 37 of 73 |