Motorola T1/E1 manual Procedure 12 Configuring the E1 ports using the CLI

Canopy T1/E1 Multiplexer	September 2004
	T1/E1 Multiplexer FPGA Version 3.4

Procedure 12: Configuring the E1 ports using the CLI

Follow this procedure to configure the E1 ports from the CLI manager.

Action	Steps
Log in	Press Enter.
	At the username prompt, enter admin.
	At the password prompt, enter password.
Set E1 line length	NOTE: If the incorrect line length is selected, the result could be decreased
	E1 quality or echo on voice lines. The default length is 133 ft.
	Enter set line [1/2/3/4] length [133, 266, 399, 533]
	where
	[1/2/3/4] represents E1 ports 1 through 4.
	[133, 266, 399, 533, 655] represents line length in feet.
	RESULT: The system responds
	Line [1/2/3/4] length [0-133 / 0.6 dB; 133-266 / 1.2
	dB; 266-399 / 1.8 dB; 399-533 / 2.4 dB; 533-655 / 3.0
	dB]
Set E1 line code	NOTE: If the line code does not match the incoming E1 settings, then
	Bipolar Violations (BPVs) will occur. The default code is HDB3.
	Enter set line [1/2/3/4] code [HDB3/AMI]
	where
	[1/2/3/4] represents E1 ports 1 through 4.
	[HDB3/AMI] represents the line coding scheme.
	RESULT: The system responds
	Line [1/2/3/4] code [HDB3/AMI]

Issue 3 Page 42 of 73