AMX NXA-WAP250G manual Diagnosing Access Point Indicators, Symptom Action Power LED is Off

Page 12

Installation

Diagnosing Access Point Indicators

Symptom	Action

POWER LED is Off	• AC power adapter may be disconnected. Check connections between the access
	point, the power adapter, and the wall outlet.

LAN LED is Off	• Verify that the access point and attached device are powered on.
	• Be sure the cable is plugged into both the access point and corresponding device.
	• Verify that the proper cable type is used and its length does not exceed specified
	limits.
	• Check the cable connections for possible defects. Replace the defective cable if
	necessary.

8	NXA-WAP250G 802.11b/g Wireless Access Point

Image 12

Contents NXA-WAP250G AMX Limited Warranty and Disclaimer Table of Contents Appendix a Troubleshooting Federal Communication Commission Interference Statement Important Note FCC Radiation Exposure StatementEC Conformance Declaration Specifications OverviewPower Connector Reset ButtonEthernet Port Installation Access Point Configuration Straight-Through WiringTwisted-Pair Cable Assignments Ethernet LAN Port Antenna Power Socket CAT5 WallMount Slots Reset Button OverviewLED Indicators Hardware DescriptionDiagnosing Access Point Indicators Symptom Action Power LED is OffSelecting an Operation Mode Access Point ModeAccess Point Mode Roaming Access Point Mode roaming for mobile usersAccess Point Mode Repeater and Bridge Mode Bridge ModeLogin Logging into the Web InterfaceUsing the Setup Wizard Operation Mode SettingNetwork Setting Setup Wizard Network SettingSetup Wizard Network Setting PPoE settings Dhcp Server/NAT Setting Wireless VAP #1 SettingSetup Wizard Wireless VAP #1 Setting WEP settings Wireless VAP #2 Setting Setup Wizard Wireless VAP #2 SettingFinish and Reboot Setup Wizard Wizard configuration donePage System Configuration Information NetworkInformation System System InformationInformation Client Client InformationInformation Network Information Event LogSystem Setting System Setting AdministrationSystem Setting Vlan Status / Operation Mode Operation ModesSystem Setting VAP Management System Settings Reset SystemWireless VAP Settings Wireless VAP Settings Basic SettingWireless VAP Settings Channel Setting Wireless VAP 1 Setting Basic SettingsWireless VAP Settings WEP Setting Authentication Mode Select Open or SharedSystem Configuration Wireless VAP Settings WPA / WPA2 Setting WPA, WPA2, WPA-WPA2 Mix ModeNetwork Settings Network Settings Dhcp Client SettingNetwork Settings Dhcp Server/NAT Setting Network Settings Dhcp Server/NAT SettingsNetwork Settings PPPoE Setting Network Settings PPPoE SettingsNetwork Settings Radius Server Setting Network Settings Radius Server SettingsTime Setting Time and LogUpgrade via the Web Updating FirmwareUpgrade via a Remote Server Firmware Upgrade Local FileSystem Configuration Page If Your WAP250G Is Stuck on the Emergent Recovery Screen Choose Download site and Install Tftp ServerWebsite for free Tftp Server Change Tftp Server Settings Copy Firmware fileEthernet Connectivity Launch Tftp ServerTftp Server Configuration dialog Re-Connect to WAP 250GPage Glossary NXA-WAP250G 802.11b/g Wireless Access Point It’s Your World Take Control