AMX NXA-WAP250G manual Re-Connect to WAP 250G, Tftp Server Configuration dialog

Page 49

Appendix A: Troubleshooting

FIG. 43 TFTP Server Configuration dialog

Step 7: Re-Connect to WAP 250G

1.Open a web browser and enter the IP Address for the WAP250G.

2.Follow the Emergent Recovery System on-screen prompts to begin the Firmware upload.

NXA-WAP250G 802.11b/g Wireless Access Point	45

Image 49

Contents NXA-WAP250G AMX Limited Warranty and Disclaimer Table of Contents Appendix a Troubleshooting Important Note FCC Radiation Exposure Statement Federal Communication Commission Interference StatementEC Conformance Declaration Overview SpecificationsReset Button Power ConnectorEthernet Port Installation Straight-Through Wiring Access Point ConfigurationTwisted-Pair Cable Assignments Reset Button Overview Ethernet LAN Port Antenna Power Socket CAT5 WallMount SlotsLED Indicators Hardware DescriptionSymptom Action Power LED is Off Diagnosing Access Point IndicatorsAccess Point Mode Selecting an Operation ModeAccess Point Mode roaming for mobile users Access Point Mode RoamingBridge Mode Access Point Mode Repeater and Bridge ModeLogging into the Web Interface LoginOperation Mode Setting Using the Setup WizardSetup Wizard Network Setting Network SettingSetup Wizard Network Setting PPoE settings Wireless VAP #1 Setting Dhcp Server/NAT SettingSetup Wizard Wireless VAP #1 Setting WEP settings Setup Wizard Wireless VAP #2 Setting Wireless VAP #2 SettingSetup Wizard Wizard configuration done Finish and RebootPage System Configuration Network InformationSystem Information Information SystemClient Information Information ClientInformation Event Log Information NetworkSystem Setting Administration System SettingOperation Modes System Setting Vlan Status / Operation ModeSystem Settings Reset System System Setting VAP ManagementWireless VAP Settings Basic Setting Wireless VAP SettingsWireless VAP 1 Setting Basic Settings Wireless VAP Settings Channel SettingAuthentication Mode Select Open or Shared Wireless VAP Settings WEP SettingSystem Configuration WPA, WPA2, WPA-WPA2 Mix Mode Wireless VAP Settings WPA / WPA2 SettingNetwork Settings Dhcp Client Setting Network SettingsNetwork Settings Dhcp Server/NAT Settings Network Settings Dhcp Server/NAT SettingNetwork Settings PPPoE Settings Network Settings PPPoE SettingNetwork Settings Radius Server Settings Network Settings Radius Server SettingTime and Log Time SettingUpdating Firmware Upgrade via the WebFirmware Upgrade Local File Upgrade via a Remote ServerSystem Configuration Page Choose Download site and Install Tftp Server If Your WAP250G Is Stuck on the Emergent Recovery ScreenWebsite for free Tftp Server Copy Firmware file Change Tftp Server SettingsEthernet Connectivity Launch Tftp ServerRe-Connect to WAP 250G Tftp Server Configuration dialogPage Glossary NXA-WAP250G 802.11b/g Wireless Access Point It’s Your World Take Control