AMX NXA-WAP250G manual Finish and Reboot, Setup Wizard Wizard configuration done

Page 23

Initial Configuration

Finish and Reboot

1.Click Finish (FIG. 15).

FIG. 15 Setup Wizard - Wizard configuration done

2.Click the Reboot button to restart the NXA-WAP250G. Rebooting of the NXA-WAP200G can take up to 90 seconds.

The NXA-WAP250G will start using any configured new IP settings, which must be used to access the web management interface.

NXA-WAP250G 802.11b/g Wireless Access Point	19

Image 23

Contents NXA-WAP250G AMX Limited Warranty and Disclaimer Table of Contents Appendix a Troubleshooting Important Note FCC Radiation Exposure Statement Federal Communication Commission Interference StatementEC Conformance Declaration Overview SpecificationsEthernet Port Power ConnectorReset Button Installation Twisted-Pair Cable Assignments Access Point ConfigurationStraight-Through Wiring Hardware Description Ethernet LAN Port Antenna Power Socket CAT5 WallMount SlotsReset Button Overview LED IndicatorsSymptom Action Power LED is Off Diagnosing Access Point IndicatorsAccess Point Mode Selecting an Operation ModeAccess Point Mode roaming for mobile users Access Point Mode RoamingBridge Mode Access Point Mode Repeater and Bridge ModeLogging into the Web Interface LoginOperation Mode Setting Using the Setup WizardSetup Wizard Network Setting Network SettingSetup Wizard Network Setting PPoE settings Wireless VAP #1 Setting Dhcp Server/NAT SettingSetup Wizard Wireless VAP #1 Setting WEP settings Setup Wizard Wireless VAP #2 Setting Wireless VAP #2 SettingSetup Wizard Wizard configuration done Finish and RebootPage System Configuration Network InformationSystem Information Information SystemClient Information Information ClientInformation Event Log Information NetworkSystem Setting Administration System SettingOperation Modes System Setting Vlan Status / Operation ModeSystem Settings Reset System System Setting VAP ManagementWireless VAP Settings Basic Setting Wireless VAP SettingsWireless VAP 1 Setting Basic Settings Wireless VAP Settings Channel SettingAuthentication Mode Select Open or Shared Wireless VAP Settings WEP SettingSystem Configuration WPA, WPA2, WPA-WPA2 Mix Mode Wireless VAP Settings WPA / WPA2 SettingNetwork Settings Dhcp Client Setting Network SettingsNetwork Settings Dhcp Server/NAT Settings Network Settings Dhcp Server/NAT SettingNetwork Settings PPPoE Settings Network Settings PPPoE SettingNetwork Settings Radius Server Settings Network Settings Radius Server SettingTime and Log Time SettingUpdating Firmware Upgrade via the WebFirmware Upgrade Local File Upgrade via a Remote ServerSystem Configuration Page Website for free Tftp Server If Your WAP250G Is Stuck on the Emergent Recovery ScreenChoose Download site and Install Tftp Server Launch Tftp Server Change Tftp Server SettingsCopy Firmware file Ethernet ConnectivityRe-Connect to WAP 250G Tftp Server Configuration dialogPage Glossary NXA-WAP250G 802.11b/g Wireless Access Point It’s Your World Take Control