AMX NXA-WAP250G manual Logging into the Web Interface, Login

Page 16

Initial Configuration

Logging into the Web Interface

In the web browser’s address bar, type the default IP address: http://192.168.1.240. The web browser displays the NXA-WAP250G’s login page.

The User ID is fixed as “Admin(case-sensitive), and the default password is “1988(FIG. 4).

FIG. 4 Login Page

It is strongly recommended that you configure a password. If a password is not configured, the management interface is not protected and anyone that can connect to the NXA-WAP250G may be able to compromise your network security.

For information on configuring a password, see the System Setting - Administration section on page 26

The home page displays the Main Menu (FIG. 5). There are two options available, you can configure the basic features of the NXA-WAP250G using the Setup Wizard’s simple steps, or you can configure all features in detail using the Advanced Setup menu.

FIG. 5 Home Page

12

NXA-WAP250G 802.11b/g Wireless Access Point

Image 16
Contents NXA-WAP250G AMX Limited Warranty and Disclaimer Table of Contents Appendix a Troubleshooting Federal Communication Commission Interference Statement Important Note FCC Radiation Exposure StatementEC Conformance Declaration Specifications OverviewReset Button Power ConnectorEthernet Port Installation Straight-Through Wiring Access Point ConfigurationTwisted-Pair Cable Assignments Ethernet LAN Port Antenna Power Socket CAT5 WallMount Slots Reset Button OverviewLED Indicators Hardware DescriptionDiagnosing Access Point Indicators Symptom Action Power LED is OffSelecting an Operation Mode Access Point ModeAccess Point Mode Roaming Access Point Mode roaming for mobile usersAccess Point Mode Repeater and Bridge Mode Bridge ModeLogin Logging into the Web InterfaceUsing the Setup Wizard Operation Mode SettingNetwork Setting Setup Wizard Network SettingSetup Wizard Network Setting PPoE settings Dhcp Server/NAT Setting Wireless VAP #1 SettingSetup Wizard Wireless VAP #1 Setting WEP settings Wireless VAP #2 Setting Setup Wizard Wireless VAP #2 SettingFinish and Reboot Setup Wizard Wizard configuration donePage System Configuration Information NetworkInformation System System InformationInformation Client Client InformationInformation Network Information Event LogSystem Setting System Setting AdministrationSystem Setting Vlan Status / Operation Mode Operation ModesSystem Setting VAP Management System Settings Reset SystemWireless VAP Settings Wireless VAP Settings Basic SettingWireless VAP Settings Channel Setting Wireless VAP 1 Setting Basic SettingsWireless VAP Settings WEP Setting Authentication Mode Select Open or SharedSystem Configuration Wireless VAP Settings WPA / WPA2 Setting WPA, WPA2, WPA-WPA2 Mix ModeNetwork Settings Network Settings Dhcp Client SettingNetwork Settings Dhcp Server/NAT Setting Network Settings Dhcp Server/NAT SettingsNetwork Settings PPPoE Setting Network Settings PPPoE SettingsNetwork Settings Radius Server Setting Network Settings Radius Server SettingsTime Setting Time and LogUpgrade via the Web Updating FirmwareUpgrade via a Remote Server Firmware Upgrade Local FileSystem Configuration Page Choose Download site and Install Tftp Server If Your WAP250G Is Stuck on the Emergent Recovery ScreenWebsite for free Tftp Server Change Tftp Server Settings Copy Firmware fileEthernet Connectivity Launch Tftp ServerTftp Server Configuration dialog Re-Connect to WAP 250GPage Glossary NXA-WAP250G 802.11b/g Wireless Access Point It’s Your World Take Control