Fortinet MR1 manual Quick Start up User Account Management, Show Interface status slot/port all

show Interface status { <slot/port> all }

Displays the Ports slot/port

Type - Indicates if the port is a special type of port

Admin Mode - Selects the Port Control Administration State

Physical Mode - Selects the desired port speed and duplex mode

Physical Status - Indicates the port speed and duplex mode

Link Status - Indicates whether the link is up or down

Link Trap - Determines whether or not to send a trap when link status changes LACP Mode - Displays whether LACP is enabled or disabled on this port

Flow Mode - Indicates the status of flow control on this port

Cap. Status - Indicates the port capabilities during auto-negotiation

2.4.3Quick Start up User Account Management

Table 2-3. Quick Start up User Account Management

Command	Details
show users	Displays all users that are allowed to access
	the switch
	User Access Mode - Shows whether the
	user is able to change parameters on the
	switch (Read/Write) or is only able to view
	(Read Only).
	As a factory default, admin has Read/Write
	access and guest has Read Only access.
	There can only be one Read/Write user and
	up to 5 Read Only users.
show loginsession	Displays all login session information

username <username> { passwd Allows the user to set passwords or change

nopasswd }	passwords needed to login
	A prompt will appear after the command is
	entered requesting the old password. In the
	absence of an old password leave the area
	blank. The operator must press enter to
	execute the command.
	The system then prompts the user for a new
	password then a prompt to confirm the new
	password. If the new password and the

31