Fortinet MR1 manual Syntax Mrinfo ipaddr, Syntax Mstat source group receiver

Syntax

mrinfo [<ipaddr>]

<ipaddr> - the IP address of the multicast capable router.

Default Setting

None

Command Mode

Privileged Exec

7.3.2.7mstat

This command is used to find the packet rate and loss information path from a source to a receiver (unicast router id of the host running mstat). The results of this command will be available in the results bufferpool which can be displayed by using "show mstat". If a debug command is already in progress, a message is displayed and the new request fails.

The <source> is the IP Address of the remote multicast-capable source. The [<receiver>] is the IP address of the receiver. The default value is the IP address of system at which the command is issued. The [<group>] is a multicast address of the group to be displayed. Default value is 224.2.0.1

Syntax

mstat <source> [<group>] [<receiver>]

<source > - the IP address of the multicast data source.

<group> - the multicast address of the group to be traced. If you leave this field blank, the multicast address 224.2.0.1 will be used. Valid addresses are 224.0.0.0 through 239.255.255.255.

<receiver > - the IP address of the host to which the mstat response will be sent by the last hop router.

Default Setting

None

Command Mode

Privileged Exec

404