Total: 5 files.
Note whether there is one file with the file type “Operation Code” or two (as in the example above). If there are two “Operation Code” files, you must first delete the oldest image file using the following command sequence (inserting the file name of the oldest operation code file in place of the example below):
Image File
date | file name | file type startup size (byte) | ||
|
| |||
2007/05/14 | Y | 127648 | ||
2007/11/20 | default.cfg | Config File | N | 28701 |
2008/04/03 | Y | 8034434 | ||
2008/05/20 | test.2 | Config File | Y | 29154 |
2.Configure an IP address on "interface vlan 1" (if not already configured):
The
You can give the switch a static IP address manually, or configure a DHCP server to provide an IP address dynamically.
To configure a dynamic IP address using DHCP:
Type the commands shown below to configure the FortiSwitch to acquire an IP address from your DHCP server:
Are you sure you want to continue? (y/n)y
To manually configure a static IP address:
If you are not using DHCP to automatically assign an IP address to the FortiSwitch, follow the steps below to configure a static IP address on the switch, substituting the appropriate IP address for the example shown. If you do not know what IP address to assign to the switch, contact your IT department.
Are you sure you want to continue? (y/n)y
36