Fortinet MR1 manual Show ip ospf area, Show ip ospf database

External LSA Checksum A number which represents the sum of the LS checksums of external link-state advertisements contained in the link-state database.

New LSAs Originated The number of new link-state advertisements that have been originated.

LSAs Received The number of link-state advertisements received determined to be new instantiations. External LSDB Limit The maximum number of non-default AS-external-LSAs entries that can be stored in the link-state database.

Default-metricRDefault value for redistributed routes.

Default Route Advertise Enable or Disable Default Route Advertise. Always Sets the router advertise 0.0.0.0/0.0.0.0 when set to "True".

Metric Specifies the metric of the default route. The valid values are (0 to 16777215).

Metric Type Metric type of the default route. The valid values are External Type 1 and External Type 2. Maximum Paths Maximum number of paths that OSPF can report for a given destination.

6.3.1.2show ip ospf area

This command displays information relevant to the OSPF router

Syntax

show ip ospf area <areaid>

Default Setting

None

Command Mode

Privileged Exec, User Exec

Display Messages

AreaID Is the area id of the requested OSPF area.

Aging Interval Is a number representing the aging interval for this area.

External Routing Is a number representing the external routing capabilities for this area. Spf Runs Is the number of times that the intra-area route table has been calculated using this area's link-state database.

Area Border Router Count The total number of area border routers reachable within this area.

Area LSA Count Total number of link-state advertisements in this area's link-state database, excluding AS external LSA's.

Area LSA Checksum A number representing the area LSA checksum for the specified AreaID excluding the external (LS type 5) link-state advertisements.

Stub Mode Represents whether the specified Area is a stub area or not. The possible values are enabled and disabled. This is a configured value.

Import Summary LSAs Enable to import LSAs into stub area.

6.3.1.3show ip ospf database

This command displays the link state database. This command takes no options. The information will only be displayed if OSPF is enabled.

318