Show interface counters | Fortinet MR1 guide

<slot/port> - is the desired interface number.

all - This parameter displays information for all interfaces.

Default Setting

None

Command Mode

Privileged Exec

Display Message

Intf: The physical slot and physical port.

Type: If not blank, this field indicates that this port is a special type of port. The possible values are: Source - This port is a monitoring port.

PC Mbr - This port is a member of a port-channel (LAG). Dest - This port is a probe port.

Admin Mode: Selects the Port control administration state. The port must be enabled in order for it to be allowed into the network. – It may be enabled or disabled. The factory default is enabled.

Physical Mode: Selects the desired port speed and duplex mode. If auto-negotiation support is selected, then the duplex mode and speed will be set from the auto-negotiation process. Note that the port's maximum capability (full duplex -100M) will be advertised. Otherwise, this object will determine the port's duplex mode and transmission rate. The factory default is Auto.

Physical Status: Indicates the port speed and duplex mode.

Link Status: Indicates whether the Link is up or down.

Link Trap: This object determines whether to send a trap when link status changes. The factory default is enabled.

LACP Mode: Displays whether LACP is enabled or disabled on this port.

Flow Mode: Displays flow control mode.

Capabilities Status: Displays interface capabilities.

5.2.1.2show interface counters

This command displays a summary of statistics for a specific interface or all interfaces.

Syntax

show interface counters {<slot/port> all}

<slot/port> - is the desired interface number.

all - This command displays statistics information for all interfaces.