Fortinet MR1 manual Configuring syslog configuration

IP Address - This is the ip address of the host configured for syslog.

Status -This specifies wether the host has been configured to be actively logging or not. Set the host to be active/out of service from the drop down menu.

Port -This is the port on the host to which syslog messages are sent. The default port is 514. Specify the port in the text field.

Severity Filter -A log records messages equal to or above a configured severity threshold. Select the severity option by selecting the corresponding line on the pulldown entry field. These severity levels have been enumerated below:

-Emergency (0): system is unusable

-Alert (1): action must be taken immediately

-Critical (2): critical conditions

-Error (3): error conditions

-Warning (4): warning conditions

-Notice(5): normal but significant conditions

-Informational(6): informational messages

-Debug(7): debug-level messages

Command Buttons

Submit - Update the switch with the values you entered.

Refresh - Refetch the database and display it again starting with the first entry in the table.

Delete - Delete a configured host.

Configuring syslog configuration Page

Configurable Data

Admin Status -For Enabling and Disabling logging to configured syslog hosts. Setting this to disable stops logging to all syslog hosts. Disable means no messages will be sent to any collector/relay. Enable means messages will be sent to configured collector/relays using the values configured for each collector/relay. Enable/Disable the operation of the syslog function by selecting the corresponding line on the pulldown entry field.

Local UDP Port This is the port on the local host from which syslog messages are sent. The default port is 514. Specify the local port in the text field.

Non-Configurable Data

443