
Note: This command has an effect only when GVRP and GMRP are enabled.
Syntax
garp timer leave < 20-600 > no garp timer leave
no - This command sets the GVRP leave time per port to 60 centiseconds (0.6 seconds).
Note: This command has an effect only when GVRP and GMRP are enabled.
Default Setting
60 centiseconds (0.6 seconds)
Command Mode
Interface Config
This command sets the GVRP leave time for all ports. Leave time is the time to wait after receiving an unregister request for a VLAN or a multicast group before deleting the VLAN entry. This can be considered a buffer time for another station to assert registration for the same attribute in order to maintain uninterrupted service. The time is from 20 to 600 (centiseconds).
Note: This command has an effect only when GVRP and GMRP are enabled.
Syntax
garp timer leave all < 20-600 > no garp timer leave all
no - This command sets the GVRP leave time for all ports to the default 60 centiseconds (0.6 seconds).
Note: This command has an effect only when GVRP and GMRP are enabled.
93