Fortinet MR1 manual Exit-overflow-interval

Syntax

distribute-list <1-199> out {rip static connected} no distribute-list <1-199> out {rip static connected}

<1-199> - The range of default list id is 1 to 199.

<no> - This command is used to specify the access list to filter routes received from the source protocol.

Default Setting

None

Command Mode

Router OSPF Config

6.3.2.24exit-overflow-interval

This command configures the exit overflow interval for OSPF. It describes the number of seconds after entering Overflow state that a router will wait before attempting to leave the Overflow State. This allows the router to again originate non-default AS-external-LSAs.

When set to 0, the router will not leave Overflow State until restarted.

Syntax

exit-overflow-interval <0-2147483647> no exit-overflow-interval

<0-2147483674> - The range of exit overflow interval for OSPF is 0 to 2147483674.

<no> - This command configures the default exit overflow interval for OSPF.

Default Setting

The default value of exit overflow interval for OSPF is 0.

Command Mode

Router OSPF Config

338